Abstract:Texture inhomogeneity usually takes place in ferritic stainless steels due to the lack of phase transformation and recrystallization during hot strip rolling, which can deteriorate the formability of final sheets. In order to work out the way of weakening texture inhomogeneity, conventional hot rolling and warm rolling processes have been carried out with an ultra purified ferritic stainless steel. The results showed that the evolution of through-thickness texture is closely dependent on rolling process, especially for the texture in the center layer. For both conventional and warm rolling processes, shear texture components were formed in the surface layers after hot rolling and annealing; sharp α-fiber and weak γ-fiber with the major component at 111<110> were developed in both cold rolled sheet surfaces, leading to the formation of inhomogeneous γ-fiber dominated by 111<112> after recrystallization annealing. In the center layer of conventional rolled and annealed bands, strong α-fiber and weak γ-fiber textures were formed; the cold rolled textures were comprised of sharp α-fiber and weak γ-fiber with the major component at 111<110>, and inhomogeneous γ-fiber dominated by 111<112> was formed after recrystallization annealing. By contrast, in the centre layer of warm rolled bands, the texture was comprised of weak α-fiber and sharp γ-fiber, and γ-fiber became the only component after annealing. The cold rolled texture displayed a sharp γ-fiber with the major component at 111<112> and the intensity of γ-fiber close to that of α-fiber, resulting in the formation of a nearly homogeneous γ-fiber recrystallization texture in the center layer of the final sheet.

Surface Peeling Reason of Hot-Rolled 06cr17ni5n Austenitic Stainless Steel Plate

Anomalous Evolution of Corrosion Behaviour of Warm-Rolled Type 304 Austenitic Stainless Steel

Analysis on peeling defects of cold-rolled sheet and its influencing factor

Microstructural Evolution and Mechanical Properties of 6cr13 Martensitic Stainless Steel Subjected to Cold Rolling and Heat Treatments

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Study on Peeling Behavior of Stainless Steel Surfacing Layer in Pressure Vessel

Cause Analysis and Precaution of Striation Defects of St12 Cold Rolled Coil

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Mechanism of Oxidation of Austenitic Stainless Steels under Conditions of Hot Rolling in Steckel Mills

Analysis of Edge Crack Defect Analysis and Control of 316L Austenitic Stainless Steel

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface

Reason for Edge Cracking of Cold-Rolled 55Mn Strip Steel and the Cold-rolling Control Measures

The effect of oxide scale of stainless steels on friction and surface roughness in hot rolling

Investigation of oxide scale on ferritic stainless steel B445J1M and its tribological effect in hot rolling

Effect of Hot Rolling Process on Surface Ridging of Cr12 Ferritic Stainless Steel

Study on Microstructure and Fatigue Properties of A473M Stainless Steel Strengthened by Surface Rolling

Oxide scale characterization of ferritic stainless steel and its deformation and friction in hot rolling

Peeling off Reason of Ag Coating on 6063 Alloy and Its Solving Method

Factors Affecting the Development of Oxide Scales on Austenitic Stainless Steels during Hot Rolling in Steckel Mills

Initiation of Sticking during Hot Rolling of Stainless Steel Plate

Evolution of Through-Thickness Texture in Ultra Purified 17%cr Ferritic Stainless Steels