Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

PREPARATION IN SITU OF TiO2 SURFACE LAYERS ON SiO2 FIBERS BY PRECURSOR CONVERSION METHOD

PREPARATION OF NANO TiO2 ON SURFACE OF SILICA

INFLUENCE OF WATER CONTENT ON CONTENT AND CHARACTERISTIC OF TiO2 DURING PREPARATION OF TiO2 NANOPARTICLES ON SiO2 SURFACE

Titanium Dioxide Fibers Prepared by Sol–gel Process and Centrifugal Spinning

Preparation of TiO2/SiO2 Composite by Chemical Coating Method

Fabrication and Photocatalytic Activity of Tio2 Nanofiber Membrane

Study on the Preparation and Photocatalytic Properties of Au/TiO2 Composite Fibers

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Preparation of TiO2 Nanofibres and Influence of Calcination Temperature on Photocatalytic Activity

Preparation and Properties of TiO2/illite Composites Synthesized at Different Hydrothermal Ph Values

Preparation of silicon-doped TiO2 fiber and supported TiO2 and comparison study of their photocatalytic activity

Synthesis of Polytitanocarbosilane and Preparation of Si–C–Ti–B Fibers

Preparation and photocatalytic performance of fibrous Tb3+-doped TiO2 using collagen fiber as template

Preparation, Characterization and Electronic Structures of Fe-doped TiO2 Nanostructured Fibers

PREPARATION OF TRANSPARENT ULTRAFINE TITANIUM DIOXIDE

Preparation and Characterization of Silica-modified Titanium Dioxide Nanoparticles by Co-precipitation Method

Synthesis and characteristics of polycarbomethylsilane via a one-pot approach

Boron-carbon doped Silicon Carbide Fibers: Preparation and Property

Microstructure and phase evolution of TiO2 precursors prepared by peptization-hydrolysis method using polycarboxylic acid as peptizing agent

Synthesis of ordered mesoporous crystalline carbon-anatase composites with high titania contents.

Formation of Tio2 Composites on Activated Carbon Modified by Nitric Acid and Their Photocatalytic Activity