Abstract:Mass spectrometry is widely used analytical technique due to its high specificity for analyte identification as well as its high sensitivity.A custom mass spectrometer instrument based on a cylindrical ion trap (CIT)was built and its working parameters were optimized.An electron ionization(EI)source was chosen for experimental simplic-ity and availability of standard EI spectral libraries.The custom designed CIT was con-sisted of a pair of endcap electrodes and a ring electrode(r0=1 0 mm,z0=8.9 7 mm).A high voltage RF signal which needed to be applied directly to the ring electrode to pro-duce appropriate quadrupole was initially created by an RF generator at low voltage.A power amplifier and a voltage amplifier circuit were used to amplify to an appropriate power level.The boundary ej ection method was used.An electron multiplier,a current amplifier and NI PCIe data acquire card made up the ion detection and data acquisition system.The EI source,CIT and electron multiplier (EM)were mounted in a rail which ensured they were aligned precisely.The software designed in LabVIEW controlled the timing of the whole system.Several MATLAB programs were written to perform post-processing operations on saved MS data files.In order to obtain the optimal working pa-rameters,different values of filament current,bias voltage of EI,background pressure, voltage on the EM detector and mass scan rate were tested in the vacuum chamber.The trends of spectral peak were obtained:1)Signal intensity increased with the heating current supplied to the EI source due to the increased electron emission at higher tem-perature;2)The bias voltage of EI affected the kinetic energy of ions.With the increas-ing of the voltage,the signal intensity increased.When the voltage increased to a cer-tain range,the intensity fluctuated.In most common EI sources,a kinetic energy of 70 V was used.So the bias voltage was set as 70 V;3)Both signal intensity and resolution increased when background pressure was increased from 1×10-4to 6×10-4Pa.When the pressure further increased,the performance decreased;4)Signal intensity was pro-portional to the voltage on the EM detector.Considering the signal intensity and the lifetime of EM,a voltage of 1.75 kV was used;5)Mass scan rate had influence on the signal intensity and resolution.When the scan rate was too fast,the various ions bunched together and increased the signal intensity but reduced the resolution.Slowing the scan rate caused the peaks to spread apart resulting in increased resolution.By using the optimized parameters,several experiments were carried out.The results showed that the mass spectrum was accurate and the resolution was about 300.The MS plat-form performed well which laid a foundation of further research.To further improve resolution,axial RF will be applied to the endcap electrode to perform resonance ej ection in the following work and based on this platform the operation method for high-pressure MS will be explored.

Design of Vacuum System for ESI Ion Trap Mass Spectrometer

Preliminary Development of Electrospray Ionization Rectilinear Ion Trap Mass Spectrometry

Design and Performance of Digital Rectilinear Ion Trap Mass Spectrometer

Design of a selective interface for electrospray ionization-mass spectrometry.

Design of an atmospheric pressure ionization vacuum interface and its application on electrospray ioniza-tion time-of-flight mass spectrometer.

Introduction to Ion Trap Mass Spectrometer

Developing a Vacuum Electrospray Source to Implement Efficient Atmospheric Sampling for Miniature Ion Trap Mass Spectrometer

Development of Electrospray/Photoionization MiniatureIon Trap Mass Spectrometer

Research on Key Techniques of Cylindrical Ion Trap Mass Spectrometer and Parameters Optimization

New progresses in the development of miniature ion trap mass spectrometers

Development of a Low Power Miniature Linear Ion Trap Mass Spectrometer with Extended Mass Range

Design and Development of a Scanning Magnet for High-Resolution Mass Spectrometry

Quantification and Evaluation of Ion Transmission Efficiency in Two-Stage Vacuum Chamber Miniature Mass Spectrometer.

Low-Vacuum Quadrupole Mass Filter Using a Drift Gas

Design and research of the electron bombardment ion source for double focusing magnetic mass spectrometer

Miniature Rectilinear Ion Trap Mass Spectrometry

Development of a vacuum measurement and control system for quadrupole mass spectrometer

Influence of the Capillary Design and Conditions upon the Transmission Efficiency of a Portable Ion Trap Mass Spectrometer

Design of a Laser Ionization Source and Its Application on Desktop Time-of-Flight Mass Spectrometer

Simulation of Low-Vacuum Cylindrical Ion Trap Mass Spectrometry

Recent Developments of Miniature Ion Trap Mass Spectrometers