Abstract:Mass spectrometry is widely used analytical technique due to its high specificity for analyte identification as well as its high sensitivity.A custom mass spectrometer instrument based on a cylindrical ion trap (CIT)was built and its working parameters were optimized.An electron ionization(EI)source was chosen for experimental simplic-ity and availability of standard EI spectral libraries.The custom designed CIT was con-sisted of a pair of endcap electrodes and a ring electrode(r0=1 0 mm,z0=8.9 7 mm).A high voltage RF signal which needed to be applied directly to the ring electrode to pro-duce appropriate quadrupole was initially created by an RF generator at low voltage.A power amplifier and a voltage amplifier circuit were used to amplify to an appropriate power level.The boundary ej ection method was used.An electron multiplier,a current amplifier and NI PCIe data acquire card made up the ion detection and data acquisition system.The EI source,CIT and electron multiplier (EM)were mounted in a rail which ensured they were aligned precisely.The software designed in LabVIEW controlled the timing of the whole system.Several MATLAB programs were written to perform post-processing operations on saved MS data files.In order to obtain the optimal working pa-rameters,different values of filament current,bias voltage of EI,background pressure, voltage on the EM detector and mass scan rate were tested in the vacuum chamber.The trends of spectral peak were obtained:1)Signal intensity increased with the heating current supplied to the EI source due to the increased electron emission at higher tem-perature;2)The bias voltage of EI affected the kinetic energy of ions.With the increas-ing of the voltage,the signal intensity increased.When the voltage increased to a cer-tain range,the intensity fluctuated.In most common EI sources,a kinetic energy of 70 V was used.So the bias voltage was set as 70 V;3)Both signal intensity and resolution increased when background pressure was increased from 1×10-4to 6×10-4Pa.When the pressure further increased,the performance decreased;4)Signal intensity was pro-portional to the voltage on the EM detector.Considering the signal intensity and the lifetime of EM,a voltage of 1.75 kV was used;5)Mass scan rate had influence on the signal intensity and resolution.When the scan rate was too fast,the various ions bunched together and increased the signal intensity but reduced the resolution.Slowing the scan rate caused the peaks to spread apart resulting in increased resolution.By using the optimized parameters,several experiments were carried out.The results showed that the mass spectrum was accurate and the resolution was about 300.The MS plat-form performed well which laid a foundation of further research.To further improve resolution,axial RF will be applied to the endcap electrode to perform resonance ej ection in the following work and based on this platform the operation method for high-pressure MS will be explored.

Simulation of Low-Vacuum Cylindrical Ion Trap Mass Spectrometry

Simulation of Sensitivity in Quadrupole Mass Spectrometer at Low Vacuum

Low-Vacuum Quadrupole Mass Filter Using a Drift Gas

Following the Ions Through a Mass Spectrometer with Atmospheric Pressure Interface: Simulation of Complete Ion Trajectories from Ion Source to Mass Analyzer.

A simple numerical simulation model can elucidate the key factors for designing a miniaturized ion trap mass spectrometer

Performance assessment of a portable mass spectrometer using a linear ion trap operated in non-scanning mode

Computer Simulations of a New Toroidal-Cylindrical Ion Trap Mass Analyzer

Numerical Simulation for Mass Spectrometry Instrumentation

Introduction to Ion Trap Mass Spectrometer

Development of a Low Power Miniature Linear Ion Trap Mass Spectrometer with Extended Mass Range

Flowing Gas in Mass Spectrometer: Method for Characterization and Impact on Ion Processing.

Research on Key Techniques of Cylindrical Ion Trap Mass Spectrometer and Parameters Optimization

Modeling and Simulation of Mass Spectrum of Rectangular Ion-Trap

Performance of a Low Voltage Ion Trap

Miniature cylindrical ion trap mass spectrometer.

High-Throughput Mass Spectrometer Using Atmospheric Pressure Ionization and a Cylindrical Ion Trap Array

Ion transfer between ion source and mass spectrometer inlet: electro-hydrodynamic simulation and experimental validation

Numerical Analysis and Quantification of Transfer Efficiency Coupled with Capillary and Quadrupole Ion Guide in an API-MS System

Experimental and Simulation Investigation of Ion Transfer in Different Sampling Capillaries.

Simulation of Unidirectional Ion Ejection in Linear Ion Traps with Asymmetric Radiofrequency Voltage

Simulation of the ion trajectories in the ion detection analysis