Abstract:Aero-engine nacelles have to fulfill design requirements at both cruise and off-design conditions. Under engine windmilling conditions the ingested streamtube massflow is relatively low. A key off-design condition is take-off, which, in conjunction with an engine windmilling scenario, results in the stagnation point of the ingested streamtube being located significantly inside the intake. The combination of high angle of attack and low engine massflow rates leads to a strong flow acceleration and subsequent diffusion of the boundary layer on the upper quadrants of the external nacelle cowl, which can terminate with subsonic separation from the leading-edge. Under this condition, Reynolds number effects can play a dominant role on the separation onset and characteristics and 3D-annular wind tunnel tests cannot always achieve Reynolds' number equivalent to full scale. A novel quasi-2D rig configuration representative of the aerodynamics of a full-size aero-engine nacelle under windmilling end of runway conditions examined in detail the characteristics of the boundary layer on the external cowl of a nacelle prior to diffusion-induced separation. Separation of the boundary layer was independently promoted through changes to represent different engine massflow rates and freestream Mach number on the rig to determine the limits of steady Reynolds Averaged Navier Stokes (RANS) methods to discern the onset of boundary layer separation. For the conditions and geometry investigated, the combined experimental and computational results showed that there was laminar to turbulent transition of the boundary layer ahead of the subsonic diffusion. The work showed that steady RANS can predict the onset of boundary layer separation with an uncertainty of approximately 10% on notional engine massflow rate and 0.05 on freestream Mach number relative to a nominal operating freestream Mach number of 0.25. This provides guidance for the industrial design and optimization of future windmilling-tolerant nacelles for large ultra-high bypass ratio turbofan engines.

Study on Influence of Wing-mounted Engine Nacelle on Aerodynamic Performance of High-Lift System

Nacelle Strake's Aerodynamic Characteristics Effects on High-lift Configuration of Transport Aircraft

Numerical research of the nacelle strake on a civil jet

Study on the Influence of a Powered Nacelle on the Wake Vortex Characteristics of Wide-Body Aircraft

Aerodynamics of aero-engine installation

Study of the Aerodynamic Characteristics on the Computed Flowfield During Thrust Reversers Operation

Numerical study on the influence of inlet distortion on integrated nacelle fans based on coupling crosswind and angle of attack

Numerical Optimization of Transonic Natural Laminar Flow Nacelles

Numerical Simulation of on Two-Dimensional High Lift Device Noise by SNGR Method

Numerical Investigation of the Intercooler Performance of Aircraft Piston Engines under the Influence of High Altitude and Cruise Mode

An Artificial Neural Network Approach for Aerodynamic Performance Retention in Airframe Noise Reduction Design of a 3D Swept Wing Model

Study on Airfoils and Aerodynamics of High-Speed Aircraft Propeller

Aeroacoustic investigation of multi-directional wings aligned in tandem under wing-in-ground effect

A Practical Optimization Design Method for Transport Aircraft Wing/Nacelle Integration

Design and Numerical Studies of Nacelle Anti-Icing System

Aerodynamic Optimization Framework for a Three-Dimensional Nacelle Based on Deep Manifold Learning-Assisted Geometric Multiple Dimensionality Reduction

A nacelle inlet design approach with more three-dimensional geometric consideration

Numerical and experimental investigations of diffusion-induced boundary layer separation on aero-engine nacelles

Research Progress in Numerical Simulation of Aircraft Wing Flow Field

Study on improvement of low speed pitching moment characteristics of civil aircraft

Experiment study of propulsion-induced flow on aircraft aerodynamics