Abstract:A novel series of linear, high molecular weight aromatic copolymers containing trifluoromethyl and dimethylamino groups was synthesized via facile super-acid catalyzed polyhydroxyalkylation and investigated as CO 2 gas separation membrane materials. The molar ratio of the two ketone comonomers used in copolymerization, trifluoroacetophenone (TFAp) and N,N-dimethylamino trifluoroacetophenone (dMATFAp), was systematically varied to produce five copolymers with different dMATFAp contents ranging from 12 to 73 %. The influence of dMATFAp content on physicochemical and mechanical properties as well as pure gas and water vapor separation performance was studied. All synthesized copolymers displayed excellent film forming ability, high thermal stability and high T g values (T gs > 380 °C). Pure gas permeability measurements revealed that the increase of dMATFAp molar content from 12 % to 34 % resulted in improved gas permeability, while, on the contrary, further increase of dMATFAp content from 34 to 73 % led to substantial gas permeability decrease ascribed to FFV decrease. In particular, among copolymers, the one with dMATFAp content of 34 % presented the highest CO 2 permeability value of 290 Barrer due to its highest CO 2 diffusion and CO 2 solubility coefficients associated with its higher FFV value. The CO 2 /CH 4 performance of synthesized copolymers fell very close to 2008 upper bound limit and exceeded most of the super-acid catalyzed copolymer membranes reported in the literature and commercial membranes. CO 2 /CH 4 and CO 2 /N 2 selectivity values for the different synthesized copolymers were in the range of 29.9–40 and 22.7–44, respectively. The study of the effect of dMΑTFA on water permeability unveiled that the membrane with the highest dMΑTFAp molar content (73 %) showed the highest water permeability value (23,100 Barrer) as well. This was attributed to the increased concentration of N-methyl substituent of dMΑTFAp which can interact with water molecules thereby increasing solubility. Under process gas stream conditions using a mixture of 3 % H 2 O-48.5 % CO 2 -48.5 % CH 4 , both CH 4 and CO 2 permeability were significantly reduced (by 35 % and 47 %, respectively) due to the preferential sorption of water vapor over other gases present in the mixture, highlighting the negative effect of water vapor on gas permeability. Accordingly, the CO 2 /CH 4 separation factor was slightly increased from 23.8 to 29. Finally, stability test of the copolymer (BP-TFAp) 66 -(BP-dMATFAp) 34 at 40 °C under humid mixed gas conditions showed that CO 2 and CH 4 permeability remained unchanged for one month after an initial condition stabilization that is required implying that these copolymer structures are promising materials for CO 2 separation.

Selective Permeation of CO2 Through a Composite Membrane with a Separation Layer of 2-N,n-dimethyl Aminoethyl Methacrylate and Acrylic Acid Copolymer

CO2 Facilitated Transport Through an Acrylamide and Maleic Anhydride Copolymer Membrane

Selective CO2 Separation from CO2−N2 Mixtures by Immobilized Carbonate−Glycerol Membranes

Copolymer Membrane Preparation of 2-(N,n-dimethyl Aminoethylme) and Acrylonitrile and Its Gas Permeance Performance

Permeation of CO2 and CH4 Through a 2-(N,n-dimethyl Amino) Ethyl Methacrylate and Acrylonitrile Copolymer Membrane

Sorption Behavior and Separation Performance of Novel Facilitated Transport Membranes for CO2/CH4 Mixtures

Improving CO2 Permeation and Separation Performance of CO2-philic Polymer Membrane by Blending CO2 Absorbents

Poly (Vinyl Alcohol) Composite Membrane with Polyamidoamine Dendrimers for Efficient Separation of CO2/H2 and CO2/N2

Performance of Multilayer Composite Hollow Membrane in Separation of CO2 from CH4 in Mixed Gas Conditions

Hybrid Organosilica Membrane with High CO2 Permselectivity Fabricated by a Two-Step Hot Coating Method

Preparation of a PVA/Chitosan/Glass Fiber Composite Membrane and the Performance in CO2 Separation

Selective Separation of Low Concentration CO2 Using Hydrogel Immobilized CA Enzyme Based Hollow Fiber Membrane Reactors

High-performance multi-layer composite membrane with enhanced interlayer compatibility and surface crosslinking for CO2 separation

High-efficiency CO2 separation using hybrid LDH-polymer membranes

Novel PMDA-ODA Polyimide / Polystyrene Nanocomposite Membranes for Carbon Dioxide Separation

Enhanced polyphosphazene membranes for CO2/CH4 separation via molecular design

Fabrication of Polydimethysiloxane (PDMS) Dense Layer on Polyetherimide (PEI) Hollow Fiber Support for the Efficient CO2/N2 Separation Membranes

Fabrication and Characterization of Poly(vinylidene Fluoride)–polytetrafluoroethylene Composite Membrane for CO2 Absorption in Gas–liquid Contacting Process

Poly ether block Amide/Polyvinyl Alcohol/ MgO nanocomposite membranes: Selectivity for CO 2 and CH 4 gases

Synthesis of fluorinated ether free aromatic backbone copolymers containing trifluoromethyl and dimethylamino groups for CO 2 separation: Investigation of pure and mixed gas performance under dry and humid conditions

Improved CO 2 separation performance of mixed matrix membranes via expanded layer double hydroxides and methanol post-treatment