Abstract:For improving the functionality and signal speed of electronic devices, electronic components have been miniaturized and an increasing number of elements have been packaged in the device. As a result there has been a steady rise in the amount of heat necessitated to be dissipated from the electronic device. Recently microchannel heat sinks have been emerged as a kind of high performance cooling scheme to meet the heat dissipation requirement of electronics packaging, In the present study an experimental study of subcooled flow boiling in a high-aspect-ratio, one-sided heating rectangular microchannel with gap depth of 0.52 mm and width of 5 mm was conducted with deionized water as the working fluid. In the experimental operations, the mass flux was varied from 200 to 400 kg/m2s and mposed heat flux from 3 to 20 W/cm2 while the fluid inlet emperature was regulated constantly at 90 C. The boiling curves, flow pattern and onset of nucleate boiling of subcooled flow boiling were investigated through instrumental measurements and a high speed camera. It was found that the lope of the boiling curves increased sharply once the superheat needed to initiate the onset of nucleate boiling was attained, and he slope was greater for lower mass fluxes, with lower superheat equired for boiling incipience. As for the visualization images, or relatively lower mass fluxes the bubbles generated were arger and not easy to depart from the vertical upward placed Yarrow microchannel wall, giving elongated bubbly flow and reverse backflow. The thin film evaporation mechanism dominated the entire test section due to the elongated bubbles and transient local dryout as well as rewetting occurred. Meanwhile the initiative superheat and heat flux of onset of nucleate boiling were compared with existing correlations in the literature with good agreement.

Dispersed flow film boiling in vertical narrow annular gaps

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

New Poiseuille-Couette Flow Of Variable Viscosity Fluid In Microscale Gap Between Parallel Plates

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

A New Correlation For Subcooled Flow Boiling Heat Transfer In A Vertical Narrow Microchannel

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Heat transfer correlation of smooth inverted annular film boiling in a circular tube

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Regulation of Gas-Liquid Stratified Flow Boiling Dynamic Instabilities in Horizontal Tube: Effects of Heat Load Distribution and Wall Thermal Capacity

Experimentally investigating effects of gap size and injection flowrate on heat transfer and boiling characteristics for the downward facing wall heating

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Flow Boiling in Horizontal Annuli Outside Horizontal Smooth, Herringbone and Three-Dimensional Enhanced Tubes

Visualized Investigation of Gas–liquid Stratified Flow Boiling of Water in a Natural Circulation Thermosyphon Loop with Horizontal Arranged Evaporator

Water Flow Boiling in a Partially Modified Microgap with Shortened Micro Pin Fins

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Heat Transfer Characteristics And Flow Pattern Visualization For Flow Boiling In A Vertical Narrow Microchannel

Numerical simulation of boiling behavior in vertical microchannels

A comprehensive analysis of the gap size influence on boiling crisis in narrow rectangular channels

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel