Abstract:Time-resolved imaging pump–probe reflectometry is an established technique to characterize the dynamic processes occurring during the material ablation upon ultrashort pulsed laser irradiation. In the phase explosion regime, however, the presence of an expanding liquid–vapor mixture on top of the ablated material makes an unambiguous determination of the transient ablation topography almost impossible, especially when only front-side pump–probe reflectometry is used. To circumvent this limitation, the front-side reflectometry was complemented by rear-side reflectometry, where the probe radiation does not interact with the liquid–vapor mixture, and the underneath ablation kinetics of the material becomes observable. To interpret the measured front- and rear-side reflectances, an optical multilayer model of the ablation process was developed. Its applicability is demonstrated on a thin chromium film that was ablated by a single pump pulse. The optical model replicates the Newton rings measured during spallation and phase explosion very well, which allows the reconstruction of the transient ablation topography. The combination of the front- and rear-side reflectometry with modeling offers a valuable tool for studying the ablation processes in thin metal films, because it overcomes the challenges of the phase explosion regime, and thus enhances the understanding of material dynamics upon laser irradiation.

X-ray photoelectron spectroscopy of KrF laser-irradiated polycarbonate films

Structuring of Poly Ether Ether Ketone by ArF Excimer Laser Radiation in Different Atmospheres

Irradiation Effects In Polycarbonate Induced By 2.1 Gevkr Ions

Thermal Influence on Excimer-Laser-induced Electrical Conductivity on Polyimide Film Surfaces

Photoablative Etching of Polymers for Integrated Optoelectronic Devices

Polymer surface reactivity enhancement by ultraviolet ArF laser irradiation: An x‐ray photoelectron spectroscopy study of polytetrafluoroethylene and polyethyleneterepthalate ultraviolet treated surfaces

X-Ray Photoelectron Spectroscopy Study of Synchrotron Radiation Irradiation of a Polytetrafluoroethylene Surface

Physical and chemical changes in polystyrene during electron irradiation using EELS in the TEM: contribution of the dielectric function

X—Ray and Extreme Ultraviolet Emission from Small—Sized Kr Clusters Irradiated by 150—fs Laser Pulses

The XPS Investigation on the PC Films Irradiated by MeV Cn+ (n = 1–5) Cluster Ions

Experimental Investigation on Ablation Behaviors of CFRP Laminates in an Atmospheric Environment Irradiated by Continuous Wave Laser

Photoablation of polymers

EUV ablation of organic polymers at a high fluence

Transient ablation topography of a thin chromium film after ultrashort pulsed laser irradiation in the spallation and phase explosion regime

XPS and FTIR Studies of Polytetrafluoroethylene Thin Films Obtained by Physical Methods

Atomic-scale insight into the pyrolysis of polycarbonate by ReaxFF-based reactive molecular dynamics simulation

KrF-excimer Laser Irradiation on the Soda-Lime Silicate Glass

Ultraviolet Laser Ablation of Organic Polymer Films

INTERFACIAL MICROSTRUCTURE OF HIGH-κ DIELECTRIC CaZrOx FILMS DEPOSITED BY PULSE LASER DEPOSITION IN LOW OXYGEN PRESSURE

Femtosecond laser pulse inducing hydrophilicty and hydrophobicity on polycarbonate surfaces

Laser Photoablation of Poly-Ethylcyanoacrylate and Spin-On-Glass Photoresists