Abstract:Three-dimensional (3D) titania nanostructures assembled with ordered rutile nanorods have been fabricated via a surfactant-free and single-step solvothermal route. The effects of preparation parameters, including the reaction temperatures and the reactant concentrations, on the microstructure, optical properties and photocatalytic activity of the 3D TiO2 nanostructures were investigated. The results revealed that 3D TiO2 microspheres possessed a dandelion-like morphology composed of radially packed rutile nanorods. Increasing the reaction temperature leads to the formation of larger rutile crystals, but reduced the aspect ratios of nanorods. The morphology of products was dominated by irregular shapes with low titanium precursor concentration. The optical reflectance, absorption and photocatalytic properties of the samples were found to be significantly dependent on their morphology. 3D dandelion-like structures with tapered tips showed lower reflectance, more efficient light harvesting, higher surface area and consequently higher photocatalytic activity compared with those with flat tops and fragment of nanorod sectors. Moreover, TiO2 products prepared with 0.4M titanium precursor solution at 150 and 120°C showed better or equivalent photocatalytic activity compared with Degussa P25 owing to high light harvesting ability as well as less aggregation for the unique 3D dandelion-like hierarchical structure. The growth mechanism of the 3D dandelion-like nanostructures under various preparation conditions was also discussed.

Influence of acid catalyst on crystalline microstructure and photocatalytic property of TiO2 sol

Controllable Hydrothermal Synthesis, Optical and Photocatalytic Properties of TiO2 Nanostructures

Study on in-situ Modification of Vinyl Acetate-Acrylate Latex by Anatase TiO2 Sol

Tuning the Photoelectronic and Photocatalytic Properties of Single-Crystalline TiO 2 Nanosheet Array Films with Dominant {001} Facets by Controlling the Hydrochloric Acid Concentration

In-Situ Anatase Flake Crystals Prepared By Sol-Gel Method At Low Temperature

Influence of Preparation Method on Morphology and Photocatalysis Activity of Nanostructured TiO2.

In-Suit Preparation of Cubic Anatase Tio2 Crystals and Its Photocatalysis Property on Rhodamine B

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

Hydrothermal synthesis and photocatalytic property of CaTiO 3 assisted with sodium citrate

Effect of Calcination Temperature on Crystal Structure and Photocatalytic Prop- Erty of TiO2/Diatomite Nanoparticles

Solvothermal Synthesis of Nanosized Tio2 Particles with Different Crystal Structures and Their Photocatalytic Activities

Effects of Acid on the Microstructures and Properties of Three-Dimensional TiO 2 Hierarchical Structures by Solvothermal Method

Preparation and investigation of TiO2 Sol containing nanometer anatase crystalline grains

Preparation and Analysis of Photocatalytic TiO2 Sol

Room‐Temperature Hydrolysis of Potassium Titanyl Oxalate and Water‐Assisted Crystallization for TiO2 with High Photocatalytic Activity

Solvothermal Growth of Three-Dimensional TiO2 Nanostructures and Their Optical and Photocatalytic Properties

Hydrothermal Synthesis and Photocatalytic Property of CaTiO_3 Assisted with Sodium Citrate

Preparation and Investigation of TiO<sub>2</sub> Sol Containing Nanometer Anatase Crystalline Grains

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Preparation of TiO2 Nanofibres and Influence of Calcination Temperature on Photocatalytic Activity