Abstract:As one of the key components in scanning near-field optical microscopes (SNOM), optical fiber probes can be fabricated by use of either laser-heated pulling or chemical etching. For high-resolution near-field imagine, the nearfield optical signal is rapidly attenuated as the aperture of probes decreases. It is thus important to fabricate probes optimized for aperture size and optical transmission. We present a two step fabrication method of 50%similar to 70% reproducibility to obtain probes with high optical transmission efficiency as well as small tip diameters. First, optic fiber probes with the transitional taper in hyperbolic or parabolic shape are produced by use of the simple home-made device for heating-pulling. Then, a rapid chemical etching with 40% buffered hydrofluoric acid is used to sharpen the tip while keeping the taper shape and the conic angle unchanged. The method renders us to achieve probes with tip diameters in the range of 20nm similar to 200nm and the tape angle near the tip apex in the range of 20 degrees similar to 60 degrees. Particularly, the length of the non-propagating evanescent wave modes region decreases greatly to tens of micrometers or even less. In order to test the achieved probes, we give the photon tunneling decay curve and scanning near-field optical image of holographic grating by use of PSTM mode and collection-mode SNOM, respectively. In addition, an approach curve of shear force with hyperbolic probe is shown to verify its applicability to sample-tip distance regulation on basis of the principle of shear-force.

The Preparation of Optical Fibre Nanoprobe and Its Application in Spectral Detection

A Dual-Mode Optical Fiber Sensor for SERS and Fluorescence Detection in Liquid

Fabrication And Characterization Of Near-Field Optical Fiber Nanoprobes With High Resolution And High Transmission Efficiency

Analysis and preparation of optical fiber probe in scanning near-field optical microscope

Development of optical fiber probe for the scanning near-field optical microscope

A Method to Control the Fabrication of Etched Optical Fiber Probes with Nanometric Tips

Fabrication of High‐quality SNOM Probes by Pre‐treating the Fibres Before Chemical Etching

Optimization of Passive and Active Fiber Probe of Scanning Near-Field Optical Microscopy

A Self-Assembled Plasmonic Optical Fiber Nanoprobe for Label-Free Biosensing

Simple and Low‐Cost Plasmonic Fiber‐Optic Probe as SERS and Biosensing Platform

In situ comprehensive characterization of optoelectronic nanomaterials for device purposes.

Fabrication and Application of Nearfield Optical Fibre Probe

Optical Fiber Probe with Integrated Micro-Optical Filter for Raman and Surface-Enhanced Raman Scattering Sensing

Electroless Nickel Plating on Optical Fiber Probe

Ultrafine Fiber Raman Probe with High Spatial Resolution and Fluorescence Noise Reduction

Preparation of Tapered Fibers-optic and Silanization on the Submicron Tip of Fibers-optic

Fabrication and Characterization of Fiber-Optic Nano-Probes with High Transmission Efficiency and High Resolution

Sub millimetre flexible fibre probe for background and fluorescence free Raman spectroscopy

Fabrication of high-quality fiber micro-probe for near-field optical microscope by laser-assisted melting and pulling method

A Flat-Based Plasmonic Fiber Probe for Nanoimaging

A Tapping-Mode Tuning Fork with A Short Fibre Probe Sensor for A Near-Field Scanning Optical Microscope