Abstract:As one of the key components in scanning near-field optical microscopes (SNOM), optical fiber probes can be fabricated by use of either laser-heated pulling or chemical etching. For high-resolution near-field imagine, the nearfield optical signal is rapidly attenuated as the aperture of probes decreases. It is thus important to fabricate probes optimized for aperture size and optical transmission. We present a two step fabrication method of 50%similar to 70% reproducibility to obtain probes with high optical transmission efficiency as well as small tip diameters. First, optic fiber probes with the transitional taper in hyperbolic or parabolic shape are produced by use of the simple home-made device for heating-pulling. Then, a rapid chemical etching with 40% buffered hydrofluoric acid is used to sharpen the tip while keeping the taper shape and the conic angle unchanged. The method renders us to achieve probes with tip diameters in the range of 20nm similar to 200nm and the tape angle near the tip apex in the range of 20 degrees similar to 60 degrees. Particularly, the length of the non-propagating evanescent wave modes region decreases greatly to tens of micrometers or even less. In order to test the achieved probes, we give the photon tunneling decay curve and scanning near-field optical image of holographic grating by use of PSTM mode and collection-mode SNOM, respectively. In addition, an approach curve of shear force with hyperbolic probe is shown to verify its applicability to sample-tip distance regulation on basis of the principle of shear-force.

Fabrication of High‐quality SNOM Probes by Pre‐treating the Fibres Before Chemical Etching

Fabrication And Characterization Of Near-Field Optical Fiber Nanoprobes With High Resolution And High Transmission Efficiency

Fabrication and Application of Nearfield Optical Fibre Probe

A Method to Control the Fabrication of Etched Optical Fiber Probes with Nanometric Tips

Fabrication of Large Cone Angle Optical Fiber Probe by Dynamic Chemical Etching Method

The Art of Electrochemical Etching for Preparing Tungsten Probes with Controllable Tip Profile and Characteristic Parameters

Polished nanopipets: new probes for high-resolution scanning electrochemical microscopy.

Fabrication and Characterization of Fiber-Optic Nano-Probes with High Transmission Efficiency and High Resolution

Electrochemical Preparation of STM Probes for High Aspect Ratio Nanometrology

Development of optical fiber probe for the scanning near-field optical microscope

Study on Large Cone Optical Fiber Probes by Dynamic Chemical Etching Based on Siphon Principle

Systematic Study of Electropolishing Technique for Improving the Quality and Production Reproducibility of Tungsten STM Probe

A reproducible electropolishing technique to customize tungsten SPM probe: From mathematical modeling to realization

Selective Electroless Silver Plating of Optical Fiber Probes with Protruding Tips

Fabrication of the Tip of GaAs Microwave Probe by Wet Etching

Effect of Etchant Diffusion on Tip Profiles of Glass Fiber Probes.

SNOM Probe Based on Nano-Antenna with Large Aperture and High Resolution

A High-Precision D-Shaped Fiber Polishing Method and its Sensing Characteristics of Different Polishing Depths

Simple Device and Reproducible Approach for Producing High Efficiency Optical Fiber Tips for a Scanning Near-Field Optical Microscope

Fabrication of high-aspect-ratio platinum probes by two-step electrochemical etching

Improvement of Tapping-Mode Scanning Near-Field Optical Microscope