Geometrical Effect on Creep in Cross Weld Specimens

J STORESUND,ST TU

DOI: https://doi.org/10.1016/0308-0161(94)00009-8

IF: 2.56

1995-01-01

International Journal of Pressure Vessels and Piping

Abstract:Cross weld creep testing is an experimentally straightforward method to estimate the creep strength in a welded joint. Interpretation of the results can be complicated by a complex of interacting creep properties in the weldment and differences in the stress distribution between uniaxial load cross weld creep test specimens and welded components.Stress distributions in cross weld specimens are in the present study analysed by a fraction model of the cross weld with four constituents, namely weld metal; coarse grained heat affected zone (HAZ); fine grained HAZ; parent metal. Evaluated data from each constituent are used for finite element calculations of the multiaxial stress distribution. The effects of weld and parent metal minimum strain rate ratio in the cross weld specimen are studied, comparing results of an as-welded and a postweld heat treated 1Cr0.6Mo weldment. It is found that stress enhancements appear. These enhancements can be higher when the weld and parent metal strain rates mismatch than for matched weldments.Geometrical effects such as the influence of the diameter of the specimen and the fraction of each constituent are then studied. It is found that there is a quite significant life enhancement with increasing diameter. Different rupture criteria may result in different estimation of this increase of creep life. For some weldments the cross weld specimen of a larger diameter may have a creep strength comparable with that of a pure parent metal or weld metal specimen. The location of the maximum stress enhancement in the specimen can also be altered when the diameter is changed. The change of the HAZ width has certain influence on the creep life of the specimen while the change of weld width in a practical range does not show such influence.