Abstract:This paper developed 3D elastoplastic finite element analysis (FEA) models to investigate non-axisymmetric tubes neck spinning. The three-roller mandreless neck spinning process was simulated by commercial FEA software, MSC. Marc. The distribution of the transient von Mises stresses in the contact zone between the roller and the blank, and the equivalent plastic strains after spinning were obtained. The locations and causes of fractures were analyzed. The thickness distribution of the spun workpiece was investigated numerically and experimentally. It shows that during 3D non-axisymmetric tubes spinning, diametral elongation and fractures mostly occur at the opening end of workpiece, which considered as the primary location of defects. Fractures may also occur easily at the initial spinning area, which may be considered a secondary location of defects. The distributions of equivalent stresses and strains are non-uniform during both offset and oblique 3D non-axisymmetric tubes spinning. The maximum stress and strain values occur at the location where the biggest offset or inclination is induced, while the minimum values occur at the opposite location of 180° away from the maximum values. For the oblique tube, however, the strain distribution changes gradually along the axial direction, which is different from that of the offset tube. Thinning occurs during forward path spinning and thickening occurs during backward path spinning. Therefore, for multipath neck spinning processes, forward and backward paths should be applied alternately to avoid excessive thinning or thickening of workpiece.

Finite Element Simulation of Tube Power Spinning

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Numerical simulation on power spinning process of cylindrical workpiece based on FEM

Numerical Simulation of Stagger Spinning for D406A High-Strength Steel

FEM numerical simulation of tube backword spinning

Finite Element Simulation on the Spin-Forming of the 3d Non-Axisymmetric Thin-Walled Tubes

Numerical simulation of spinning deformation of thin walled tube in necking process

3D FEM numerical simulation and experimental study on symmetric thin-wall tube neck-spinning

Numerical Simulation and Experiment Study on Tube Spinning of GH625 Reducer Tube

A Study of 3D Finite Element Modeling Method for Stagger Spinning of Thin-Walled Tube

Formability Enhancement in Hot Spinning of Titanium Alloy Thin-Walled Tube Via Prediction and Control of Ductile Fracture

Finite Element Analysis and Experimental Investigation on Deformation Mechanism of Non-Axisymmetric Tube Spinning

Finite Element Simulation of Multi-pass Power Spinning of Thin-walled Ti2AlNb Alloy Shell

Finite Element Modeling of Power Spinning of Thin-walled Ti2AlNb Alloy Shell

3D Elastic-Plastic FEM Simulation of TC4 Alloy Flow Forming

Numerical Simulation of High-Speed Spinning of Thin-Wall Copper Tube with Axial Micro-Grooves

Numerical Simulation of Neck-Spinning of Thin-Wall Micro-Grooved Copper Tube

3D FEM Simulation Analysis of Piling and Spining Force of Forward Flow Forming for Tube Parts

FEM Simulation of Tube Spinning with Non-Symmetric Distribution of Three Rollers

Evaluating The Applicability Of Gtn Damage Model In Forward Tube Spinning Of Aluminum Alloy

Simulation and Analysis on Longitudinal TIG Welding of TC4 Titanium Alloy Thin-walled Circular Tube