Abstract:This paper developed 3D elastoplastic finite element analysis (FEA) models to investigate non-axisymmetric tubes neck spinning. The three-roller mandreless neck spinning process was simulated by commercial FEA software, MSC. Marc. The distribution of the transient von Mises stresses in the contact zone between the roller and the blank, and the equivalent plastic strains after spinning were obtained. The locations and causes of fractures were analyzed. The thickness distribution of the spun workpiece was investigated numerically and experimentally. It shows that during 3D non-axisymmetric tubes spinning, diametral elongation and fractures mostly occur at the opening end of workpiece, which considered as the primary location of defects. Fractures may also occur easily at the initial spinning area, which may be considered a secondary location of defects. The distributions of equivalent stresses and strains are non-uniform during both offset and oblique 3D non-axisymmetric tubes spinning. The maximum stress and strain values occur at the location where the biggest offset or inclination is induced, while the minimum values occur at the opposite location of 180° away from the maximum values. For the oblique tube, however, the strain distribution changes gradually along the axial direction, which is different from that of the offset tube. Thinning occurs during forward path spinning and thickening occurs during backward path spinning. Therefore, for multipath neck spinning processes, forward and backward paths should be applied alternately to avoid excessive thinning or thickening of workpiece.

3D Elastic-Plastic FEM Simulation of TC4 Alloy Flow Forming

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

3D FEM Simulation Analysis of Piling and Spining Force of Forward Flow Forming for Tube Parts

Simulation and Analysis on Longitudinal TIG Welding of TC4 Titanium Alloy Thin-walled Circular Tube

FEM numerical simulation of tube backword spinning

FEM Numerical Simulation of Spinning Processing for TC4 Alloy

Formability Enhancement in Hot Spinning of Titanium Alloy Thin-Walled Tube Via Prediction and Control of Ductile Fracture

Elastic-plastic FEM analysis of roll forming process of secondary tubes from primary cyclic tubes

Numerical Simulation of Filling and Solidification of Large Complex ZTC4 Alloy Castings

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Finite Element Simulation on the Spin-Forming of the 3d Non-Axisymmetric Thin-Walled Tubes

3D Simulation of Forging Process for TC4 Alloy Rib-web Components

3-D rigid plastic FEM simulation of extruding-bulging process of tee tubes

Finite Element Analysis and Experimental Investigation on Deformation Mechanism of Non-Axisymmetric Tube Spinning

Finite Element Simulation of Tube Power Spinning

3D FEM numerical simulation and experimental study on symmetric thin-wall tube neck-spinning

Three-Dimensional Fe Simulation of Multi-Strokes Pilgering Cold Roll of Ta18 Titanium Alloy Tube: Ii Analysis of Plastic Deformation Behavior

Three-dimensional FE simulation of multi-strokes cold pilgering of TA18 titanium alloy tube: I theoretical analysis, modeling and validation

Numerical simulation on power spinning process of cylindrical workpiece based on FEM

Numerical simulation of spinning deformation of thin walled tube in necking process

Simulation Research on Cold Drawing Al Alloy Tube Without Plug