Abstract:Tyre Derived Aggregates (TDA), produced by shredding scrap car tyres, show many interesting features, such as: durability, low bulk density, thermal insulation, good drainage properties or ability to damp vibrations, which makes them a useful material for civil engineering. One of the possible applications is the partial filling of excavations with TDA during the construction of underground pipelines in order to decrease the load applied on the pipe. The article presents results of a multivariate numerical study of 2D FEM models of a flexible PVC pipe - soil system, in which the presence of a mixture of sand and TDA (tyre chips - 40% by weight) (STCh) in the backfill was simulated. The models differed in the thickness of the STCh layer ( t = 0 – 0.9 m) and inclination of the excavation walls (a trench with vertical walls or open excavations with 3:1 and 1:1 slopes). The main goal of the numerical analyses, performed by means of the Z_Soil.PC program, were to investigate the effect of the presence of the softer STCh layer in the backfill zone on the pipe deformation (relative deflection δ / D ) and internal forces in the pipe wall. The soil was simulated with the use of either the Hardening Soil Small (HSS) or Coulomb-Mohr (CM) constitutive model with the parameters' values estimated based on results of laboratory tests (published by researchers from Wollongong University). The PVC pipe was modelled as linear elastic. The results of the analyses show that, due to enhanced arching, STCh layer of the optimum thickness t = 0.55 m can effectively reduce δ / D when used in the backfill of the trench. It can also decrease the difference between the maximum and minimum bending moment in the pipe wall, leading to less ovalization of the pipe cross-section. This positive effect diminishes if the width of excavation is larger, as the model is gradually transforming towards the positive projecting conduit type. The CM model gives underestimated values of the pipe deformation and internal forces. Though, in the case of lack of all the HSS parameters' values, it is better to use the CM model with E = E 50 than E = E ur as it gives a better approximation of pipe behaviour.

Application of Controlled Low Strength Material in Backfilling of Pipe Trench

Experimental Study and Application of Controlled Low-Strength Materials in Trench Backfilling in Suqian City, China

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

Analysis and control of ground settlement of embankments in construction of cross-river shield tunnels

Performance evaluation of modified marine dredged soil and recycled in-situ soil as controlled low strength materials for underground pipe

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

RESEARCH ON SOIL DEFORMATION INDUCED BY OVERLAPPED TUNNELING IN STRATUM SOIL

New Form of Pipe Foundation on Deep Weak Subgrade

Microstructure Analysis and Mechanical Properties of Backfill Material Using Stone Sludge

Sustainable controlled low strength material from waste materials for infrastructure applications: State-of-the-art

Analysis of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

Analysis of Settlement Control Measures in Immersed Tunnel

Upcycling of wastes for sustainable controlled low-strength material: A review on strength and excavatability

Research on Slurry Flowability and Mechanical Properties of Cemented Paste Backfill: Effects of Cement-to-Tailings Mass Ratio and Mass Concentration

Physical Modeling Study on Treatment of Waste Slurry with Vacuum Preloading at Bottom Combined with Upper Surcharge Loading

Numerical Study of the Use of Tyre-Derived-Aggregate (TDA) as the Backfill Above Flexible PVC Pipeline

Preparing controlled low strength materials (CLSM) using excavated waste soils with polycarboxylate superplasticizer

Research on the interaction between trench material and pipeline under fault displacement

FINITE ELEMENT ANALYSIS OF CONTROLLED LOW STRENGTH MATERIAL PAVEMENT BASES: FREE VIBRATION ANALYSIS

Properties of Lightweight Controlled Low-Strength Materials Using Construction Waste and EPS for Oil and Gas Pipelines

Modeling pipe-soil interaction under surface loading using material point method