Abstract:Fracture tests are a necessary means to obtain the fracture properties of concrete, which are crucial material parameters for the fracture analysis of concrete structures. This study aims to fill the gap of insufficient test results on the fracture toughness of widely used ordinary C40~C60 concrete. A three-point bending fracture test was conducted on 28 plain concrete and 6 reinforced concrete single-edge notched beam specimens with various depths of prefabricated notches. The results are reported, including the failure pattern, crack initiation load, peak load, and complete load versus crack mouth opening displacement curves. The cracking load showed significant variation due to differences in notch prefabrication and aggregate distribution, while the peak load decreased nonlinearly with an increase in the notch-to-height ratio. The reinforced concrete beams showed a significantly higher peak load than the plain concrete beams, attributed to the restraint of steel reinforcement, but the measured cracking load was comparable. A compliance versus notch-to-height ratio curve was derived for future applications, such as estimating crack length in crack growth rate tests. Finally, fracture toughness was determined based on the double-K fracture model and the boundary effect model. The average fracture toughness value for C50 concrete from this study was 2.0 , slightly smaller than that of lower-strength concrete, indicating the strength and ductility dependency of concrete fracture toughness. The fracture toughness calculated from the two models is consistent, and both methods employ a closed-form solution and are practical to use. The derived fracture toughness was insensitive to the discrete parameters in the boundary effect model. The insights gained from this study significantly contribute to our understanding of the fracture toughness properties of ordinary structural concrete, highlighting its potential to shape future studies and applications in the field.

Experimental study on fracture toughness K_(Ⅱc) of concrete

Experimental Investigation on Mode II Fracture Toughness K<sub>IIC</sub> of Concrete and Fracture Behavior

Experimental Investigation On Mode Ii Fracture Toughness K-Iic Of Concrete And Fracture Behavior

Mode II fracture toughness determination of rock and concrete via Modified Direct Shear Test

Experimental Research of Mode Ⅱ Fracture Based on Self-monitoring Behavior of Carbon Fiber Reinforced Concrete

Experimental Determination of KIIC of Normal Strength Concrete

Experimental study on fracture properties of self-compacting concrete

A Fracture toughness criterion for concrete

Experimental measurement of double-K fracture parameters of concrete with small-size aggregates

Fracture Toughness of Ordinary Plain Concrete Under Three-Point Bending Based on Double-K and Boundary Effect Fracture Models

Experimental Study on the Fracture Toughness of Concrete under Different Curing Conditions

Fracture Toughness And Microstructure Of Concrete At Early-Ages

Experimental Evaluation of Fracture Toughness for Epoxy-Repaired Concrete Considering Crack Deflection Angle

A practical testing approach to determine mode II fracture energy GIIF for concrete

Determination of double- K criterion for crack propagation in quasi-brittle fracture, Part II: Analytical evaluating and practical measuring methods for three-point bending notched beams

Experimental Study on Some Factors Affecting Fracture Property of Concrete

A Quasi-2D Exploration of Mixed-Mode Fracture Propagation in Concrete Semi-Circular Chevron-Notched Disks

A comparative study on five approaches to evaluate double-K fracture toughness parameters of concrete and size effect analysis

Influence of Specimen Initial Crack Length on Double-K Fracture Parameter of Concrete

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages