New aluminum matrix composite with much lower coefficient of thermal expansion and higher strength

L. D. Wang,W. D. Fei,L. S. Jiang,C. K. Yao
DOI: https://doi.org/10.1023/A:1015749408728
2002-01-01
Journal of Materials Science Letters
Abstract:diameter of 0.5‐1 µm and length of 10‐30 µm. The aluminum matrix composite reinforced by both β-eucryptite particles and aluminum borate whiskers ((Euc + ABO)/AA6061) was fabricated by a squeeze casting technique. The total volume fraction of β-eucryptite particles and aluminum borate whiskers was 40%, and the volume ratio between β-eucryptite and aluminum borate was 2:1. The pressure for squeeze casting was 30 MPa. The casting temperature of AA6061 was 800 ◦ C and the die temperature was about 520 ◦ C. In order to compare the properties of (Euc + ABO)/AA6061 with those of other materials, the composites reinforced by aluminum borate whiskers and silicon carbide whiskers were also fabricated on the above condition. The volume fractions of the reinforcements in the two composites were 25%. Tensile specimens were cut from the squeezing composite ingot. The tensile test was carried out on a CSS4400 tensile machine. The dimension of the specimens for the CTE measurement is φ 5m m× 18 mm. The CTE curve was measured on a Netzch DIL 401C Dilatometer with a heating rate of 8 ◦ C/min. The microstructure was examined by an Olympas PMG3 type optical microscope (OM). The OM photograph of the (Euc + ABO)/AA6061 composite is shown in Fig. 1. It can be seen that the distribution of β-eucryptite particles and aluminum borate whiskers in the composite are random and homogeneous. The comparison of the tensile strengths of the various materials is given in Fig. 2, which includes (Euc + ABO)/AA6061, AA6061, AA6061 matrix composites
What problem does this paper attempt to address?