Abstract:In this study, three types of three-layer functionally graded materials (FGMs) were designed by mainting the average content of the reinforcement constant and changing the span of the composition. The B 4 C particle-reinforced Al-matrix FGMs and a homogeneous composite (HC) with the same average composition were prepared using the laser additive manufacturing technique. The FGMs had a higher average secondary-phase content and grain size than the HC. Large (black) and reticulated (white) secondary phases corresponding to B 4 C phase, T phase, and MgZn 2 were observed in the as-deposited FGM samples. The content of the secondary phase in the middle layer was generally low. The bottom layer, which was in direct contact with the substrate, exhibited the smallest grain size. The hardness and wear resistance significantly improved owing to the high B 4 C content in the top layer. The flexural behaviors of each layer of the FGM in different directions were systematically studied. The plasticity of the single-layer material decreased with increase in the B 4 C content. When the bottom layer had a high B 4 C content, the flexural ability significantly reduced. Among all the samples, G2 with 8% B 4 C particle content in the top layer exhibited the best comprehensive mechanical properties. The hardness value, wear rate of the top layer, maximum bending stress, and maximum bending strain of the FGM were 177.5 HV, 0.367 × 10 −3 mm 3 /(N·m), 585.6 MPa, and 7.36%, respectively. This study can provide a reference value for the future design and development of wear-resistant gradient materials for aerospace applications.

Study on the preparation of the SiCp/Al–20Si–3Cu functionally graded material using spray deposition

Preparation of a Functionally Gradient Aluminum Alloy Metal Matrix Composite Using the Technique of Spray Deposition

Preparation of Cu/SiC FGM by Coating Method and SPS Sintering

Fabrication and characteristics of plasma facing SiC/C functionally graded composite material

Synthesis of Functionally Graded AA7075-B4C Composite with Multi-Level Gradient Structure

Preparation and characterization of Al2O3–Ti3SiC2 composites and its functionally graded materials

Fabrication of SiC/Al functionally graded materials via filtration extrusion

Fabrication Of Sic/Cu Functionally Gradient Material By Graded Sintering

Fast fabrication of W-Cu functionally graded material by high-gravity combustion synthesis and melt-infiltration

Fabrication of Al2O3/TiC/Ni Functionally Graded Materials by Pulsed-Electric Current Sintering and Their Mechanical Properties.

Fabrication and evaluation of SiC/C functionally graded material

Preparation of 6066 Al/SiCP(+ Gr) composites by multi-layer spray deposition

Fabrication and Application of W/Cu Functionally Graded Material

Composition design and mechanical properties of B 4 C/Al-Zn-Mg-Cu functionally graded materials prepared by laser additive manufacturing

A novel functionally graded material in the ZrB2–SiC and ZrO2 system by spark plasma sintering

Fabrication of W–Cu Functionally Graded Material with Improved Mechanical Strength

A Novel Functionally Graded Material in the Ti–Si–C System

Interfacial Regulation and Fracture Mechanism of Al–Si/SiC Composites Infiltrated under Super-Gravity Field

Simulation and Study of Manufacturing of W–Cu Functionally Graded Materials by a Selective Laser Melting Process

Fabrication and evaluation of SiC/Cu functionally graded material used for plasma facing components in a fusion reactor

High Heat Flux Testing of B4C/Cu and SiC/Cu Functionally Graded Materials Simulated by Laser and Electron Beam