Abstract:Two kinds of alumina were prepared by the glycerin complexing-assisted sol-gel method and the pyrolysis of boehmite sol. The effect of modifiers, such as La, Si, Ba and both of them, on the thermal stability of alumina were studied. The introducing methods of modifiers and the ratio of Si/Al are also discussed. Alumina that prepared by the complexing-assisted sol-gel method shows larger surface area and bigger pore size than that prepared by the pyrolysis of boehmite sol. It also exhibits higher thermal stability. Compared with the impregnation method, the introduction of La into the boehmite sol makes La more effective in stabilizing alumina. However, when alumina is prepared by the complexing-assisted sol-gel method, La introduced by impregnation displays slightly more effective. If La and Si or La and Ba are added simultaneously in the gel, multiple stabilization does increase further the stability of alumina against sintering. Even heated at 1 200°C for 2 h, multiple modified alumina can still hold its surface area larger than 40 m2/g. On the contrary, if La is impregnated separately on Si or Ba modified alumina, addition of La counteracts the stabilizing effect of Si or Ba. For Si modified alumina, increasing the Si content can increase the surface area of alumina if heated below 1 000°C. However, at 1 200°C, Si-modified alumina with the Si/La ratio of 4 has best thermal stability.

Surface coating of alumina bubbles by nano-barium sulfate

Surface-Modification Of Alumina Bubble

Surface Energy Study Of Alooh Coated Calcium Carbonate By Inverse Gas Chromatography

Modification of alumina bubbles with ammonium aluminum sulphate

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

EFFECTS OF PREPARATION METHOD AND VARIOUS MODIFIERS ON THE THERMAL STABILITY OF ALUMINA

Coating of Y2O3 additive on Al2O3 powder and its effect on the wetting behaviour in the system Al2O3p/Al

Preparation of α-Al_2O_3 Ceramic Membrane Support Used Nano-alumina as Sintering-aid

The Effects of Na2WO4 Concentration on the Properties of Microarc Oxidation Coatings on Aluminum Alloy

Surface Modification Of Nano-Sic Powders By Coating With Heterogeneous Nucleation Process

Surface Modification of Ultra-fine Barium Titanate

Rare-Earth Oxide Coating for Sub-Micro Particulates Reinforced Aluminum Matrix Composites

Direct coagulation casting of alumina suspension by high valence counter ions using Ca (IO 3) 2 as coagulating agent

Effect of Surface Modification of Sub-Micron Al2O3 Particles by Rare-Earth on Interfacial Wettability of Al Matrix Composites

Synthesis and Microstructure of Boron-Doped Alumina Membranes Prepared by the Sol–gel Method

Preparation and Properties of Alumina Ceramic Foams Prepared with Cetyl Sodium Sulfate

PREPARATION OF NANO-SiO2-COATED Al2O3 CONCENTRATED SUSPENSION AND ITS GEL CASTING

Nanoparticle Coating for Advanced Optical, Mechanical and Rheological Properties

Effects of Alumina Bubble Addition on the Properties of Corundum–Spinel Castables Containing Cr2O3

The Effect of Coating Morphology on Anti-Corrosion Behavior of Modified Alumina Coating Over Aluminum Alloy

Dispersion and Gelation Properties of Alumina Systems with Isobam Assisted by Dicarboxylic Acids