Abstract:The deep lithography of thick resist layer is the primary step of LIGA technology. UV Proximity lithography, which is used to fabricate high aspect ratio MEMS normally, is investigated in this paper. The light intensity distribution in the thick photoresist layer mainly depends on the diffraction produced by the gap between mask and wafer in proximity lithography. Fresnel diffraction model is used to simulate lithography process normally, which the thin photoresist layer is used in the lithography process. But it is not accurate in deep lithography process. A correction to the Fresnel diffraction theory is used to simulate the lithography process depending on the scalar diffraction theory of light propagation in this paper. The difference of this two models is given in this paper. The simulation results show that the corrected model can obtain more accurate simulation results than the Fresnel diffraction model. The experiment results and the theory analysis both indicate that: the structure contrast decreases with the increase of the film thickness. The smaller the structure linewidth is, the faster the structure contrast decreases. The linewidth of microstructure is not equivalent from the top to the bottom, broaden in the middle part normally. The theory simulation gives the quantitative analysis.

Propagation and Diffraction of Partial Coherent Light in Uv-Lithography

Theoretical Analysis of Pattern Distortion in Proximity Lithography Based on Partial Coherent Light Theory

Light and Matter Co-Confined Multi-Photon Lithography

Sub-diffraction Optical Beam Lithography Based on a Center-Non-zero Depletion Laser

Simulation and Experimental Investigation of Immersion Flow Field in Immersion Lithography

Simulation and pattern distortion analysis of UV-LIGA based on the partial coherent light theory

Computer Simulation of Diffraction Intensity in Proximity Lithography

Research on the optical field distribution and micro-fabrication model in convex-surface laser lithography

Laser Direct Writing System and Its Lithography Properties

Photolithography Using Lateral Surface of Nanofibers

Analysis of Effective Wave-Front Affecting Diffraction Field in Proximity Lithography

Optimization of partial photo mask based on wave-front division theory in proximity lithography

Compact Ultraviolet Light-Emitting Diode-Based Lithography Illumination System with Tunable Coherent Factor

Analysis and compensation of shape distortion in UV-LIGA based on partial coherent light theory

Electromagnetic modeling of near-field phase-shifting contact lithography with broadband ultraviolet illumination

Simulation of deep UV lithography with SU-8 resist by using 365 nm light source

Information Theoretical Aspects in Coherent Optical Lithography Systems

Research on Simulation of Proximity Lithography by Angular Spectrum Method

An analytic gradient-based inverse lithography approach for partially-coherent double-exposure lithography

Simulation Of The Velocity Distribution For Immersion Lithography

Imaging simulation of maskless lithography using a DMD™