Abstract:An attempt is made in this study to research the performance of prestressed concrete pipe piles based on 10,333 pile tests. Short and medium-length piles with slenderness ratios ranging from 10 to 90 are most widely used, and the optimal length is between the range of 10~50 m. For the same bearing stratum and diameter, the capacity of pile increases with increasing pile length until a limiting value is achieved. The average pile-top settlement is approximately in the range of 10 ~ 25 mm, and the rebound rates for piles with various lengths are similar. The results show that the diameter of Φ400 and Φ500 is most widely used, accounting for 33.8% and 46.1%, respectively, and the optimal length is between the range of 10 ~ 50 m. Under conditions of, when the bearing stratum is clay, the bearing capacity of pipe piles increases with an increase in length to diameter ratio; when sandy soil, the bearing capacity firstly increases and then decreases; when with the same length to diameter ratio, the bearing capacity increases in both cases, and the latter is higher than the former. There is a large discreteness in settlement of pile top, and the average value is normally about 10 ~ 25 mm, without significant relationship with the bearing stratum. The results of statistical research will be a reliable reference for pipe pile research, design and construction in soft soil area. The results are expected to improve the understanding of prestressed concrete pipe piles and facilitate the design process.

Research on Strain-temperature Joint Test Methods of Precast Piles by Using BOTDR

Statistical research on performance of prestressed concrete pipe piles

Experimental Study on BOTDR Temperature Compensation in Bored Pile Detection

Multipoint Traveling Wave Decomposition Method and Its Application in Extended Pile Shaft Integrity Test

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Application of a Distributed Optical Fiber Sensing Technique in Monitoring the Stress of Precast Piles

Application of Distributed Optical Fiber Sensing to Testing Inner Force of Prefabricated Piles

Experiment and numerical study on the monitoring of super long cast-in-place pile temperature based on BOTDR technology

Bearing characteristic of static drill rooted pile considering condition of energy carrier

A test on base bearing capacity of static drill rooted nodular pile

Characteristics and Application of BOTDR in Distributed Detection of Pile Foundation

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Thermal integrity profiling of cast-in-situ piles in sand using fiber-optic distributed temperature sensing

Field Behavior of Pre-Stressed High-Strength Concrete Nodular Piles and PHC Pipe Piles Under Compression in Soft Soil Areas

BOTDR Monitoring Analysis of Anti-Sliding Pile Internal Force

The engineering characteristic of precast tubular pile and mixing cement pile composite foundation for deep soft ground

A Destructive Field Study on the Behavior of Pile under Ten

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile