Abstract:An air-source heat pump simulation model, accounting for evaporator and condenser pressure drop, has been developed. The model is capable of computing the heat pump's coefficient of performance (COP) under different ambient temperatures and relative humidities above frosting conditions. This research extends an existing iterative simulation method that relies on the equalization of logarithmic mean temperature differences (LMTDs) calculated through two different approaches by adding a pressure drop simulation. Frictional and acceleration pressure drop is considered, computed iteratively. Simulation results for three different refrigerants, R410A, R32 and R290, are compared. The model's accuracy is validated by comparing simulated COP values with measured COP values from the reference heat pump datasheet. The model closely replicates the measured COP values above frosting conditions, with only a slight underestimation of approximately 1.5%. Results show a substantial impact of ambient temperature on the COP. For instance, an ambient temperature of 20 ◦C, compared to 7 ◦C, results in a COP increase of up to 35%, while an ambient temperature of -10 ◦C leads to a 26% reduction in COP. Relative humidity enhances the COP if air moisture condensation becomes possible. Higher condenser capacities negatively affect the COP. The study highlights the differences in pressure drop characteristics between the condenser and the evaporator for the modeled heat pump, with maximum pressure drops of 220 kPa and 50 kPa for the condenser and evaporator, respectively. Additionally, the choice of refrigerant significantly influences pressure drop, with R32 displaying the lowest pressure drop, R410A showing the highest condenser pressure drop, and R290 causing the highest evaporator pressure drop.

Transient condition model of heat pump unit with screw compressor based on data fitting

Theoretical Analysis on Optimal Configurations of Heat Exchanger and Compressor in a Two-Stage Compression Air Source Heat Pump System

Experimental study on CO2 air source heat pump water heater

Dynamic simulation of an air-source heat pump water heater using novel modified evaporator model

Performance evaluation of air-source heat pump based on a pressure drop embedded model

Experimental Performance Analysis of an Improved Multifunctional Heat Pump System

Influence of Parameters on the Estimation of Coefficient of Performance for R410a Refrigerant

System Optimization of Co2 Heat Pump Water Heater Based on Economy

SIMULATION AND COMPARISON OF AIR-SOURCE HEAT PUMPS USING VARIABLE COMPOSITION AND CONSTANT COMPOSITION MIXTURES OR PURE REFRIGERANT

Performance representation of variable-speed compressor for inverter air conditioners based on experimental data

A simulation model of the transient performance of a heat pump

Performance Prediction of a Novel Variable Capacity Heat Pump Using a Composition Varying Device

Modelling and theoretical analysis of a high temperature heat pump system with two-stage centrifugal compressor

Simulation and Experimental Study of CO2 Transcritical Heat Pump System with Thermoelectric Subcooling

Transient flow and thermodynamics analysis of a scroll compressor based on CFD

A Water-to-Water Heat Pump Model with Experimental Validation

Investigations of the performance of a heat pump with internal heat exchanger

Optimal design for dual-stage high temperature heat pump by heat exchange area simulation

Experimental Investigation on the Performance of Transcritical CO2 Ejector–expansion Heat Pump Water Heater System

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor

Performance Analysis of the Coupled Heating System of the Air-Source Heat Pump, the Energy Accumulator and the Water-Source Heat Pump