Abstract:There must be an end gap in the piston ring because of the need of mounting and compensation for diameter after the wear of ring. Richardson’ and many author’ studies have showed the effects of the end gap to blowby and oil consumption, especially in the presence of ring or liner wear. This problem has influenced the effective utilization of the fuel energy for many years. Moreover the ring will rotate in the working cycle of engine. Once the end gaps of two compression rings come to the site of superposition, the shortest passage of gas flow is formed and blowby will be increased. The deflection of crankpin and rotation of piston were calculated according to the analytical model based on the torque transmission theory of crankshaft. The positive and negative deflections of crankpin result in the reciprocating rotation of piston in the IC engine working cycle. The peak values of deflection and rotation are in the vicinity of crank angle position of deflagration. Because the clingy moment of compression rings are less than rotational resistance moment in a few section of crank angle, they are unable to keep synchronism with piston and the rotations opposite to piston occur. The rotation angle of the second compression ring is more than that of the first ring. The superposition of the end gaps of two compression rings comes about when they turn to the same angle position. Based on above study, the structure of one compression ring in piston system should be widely used, which is in favor of reduction of friction and engine weight, pushing forward the lightweight process, being useful to the decrease of fuel consumption and emission. The pressure of combustion gas will not remarkably descend in this structure. The problem of ring suspension and pressure release in the first ring land can be resolved. Two types of rings with complete seal and economizing energy design are showed for the structure of one ring, which will also avoid the increase of end gap after the rings are worn.

Optimum Shape Design of Piston Ring Using Inverse Method

Optimizing The Shape Of Top Piston Ring Face Using Inverse Method

Design Approach for Optimization of a Piston Ring Profile Considering Mixed Lubrication

Tribological Design of the Running-in Process

Influence of Cylinder Liner Out-of-Roundness on Dynamic Lubrication and Friction Characteristics of Piston

Research on the Profile Design of Surface Texture in Piston Ring of Internal Combustion Engine

Formation of a designed compressor piston ring profile during operation

Study on the influence of piston ring assembly structure on lubricating oil consumption and optimization design

Analysis of Piston Optimization Design Based on Finite Element Analysis

Determining of the Mini-batch Piston Rings′ Rough Size

Numerical Study of Influences of Hard Particles in Lubricant on Tribological Performances of the Piston Ring

Study of the Piston System Structure of Advantageous to Low Friction and Economizing Energy

Effect of Design Parameters on the Reduction of Top Piston Ring Friction

Geometry design and optimization of piston by using finite element method

Effects Of Surface Texturing On The Tribological Behavior Of Piston Rings Under Lubricated Conditions

Optimization of Piston-Ring System for Reducing Lube Oil Consumption by CAE Approach

Study on Analysis of Ring-Pack Lubricating Oil Consumption and Improved Design

Optimal Design Apply to Orthogonal Test in Piston with Bionic Groove

Simulation and Experimental Investigation on Friction Reduction by Partial Laser Surface Texturing on Piston Ring

A New Method to Reduce Frictional Power Consumption of Piston Ring in Internal Combustion Engine

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump