Abstract:There must be an end gap in the piston ring because of the need of mounting and compensation for diameter after the wear of ring. Richardson’ and many author’ studies have showed the effects of the end gap to blowby and oil consumption, especially in the presence of ring or liner wear. This problem has influenced the effective utilization of the fuel energy for many years. Moreover the ring will rotate in the working cycle of engine. Once the end gaps of two compression rings come to the site of superposition, the shortest passage of gas flow is formed and blowby will be increased. The deflection of crankpin and rotation of piston were calculated according to the analytical model based on the torque transmission theory of crankshaft. The positive and negative deflections of crankpin result in the reciprocating rotation of piston in the IC engine working cycle. The peak values of deflection and rotation are in the vicinity of crank angle position of deflagration. Because the clingy moment of compression rings are less than rotational resistance moment in a few section of crank angle, they are unable to keep synchronism with piston and the rotations opposite to piston occur. The rotation angle of the second compression ring is more than that of the first ring. The superposition of the end gaps of two compression rings comes about when they turn to the same angle position. Based on above study, the structure of one compression ring in piston system should be widely used, which is in favor of reduction of friction and engine weight, pushing forward the lightweight process, being useful to the decrease of fuel consumption and emission. The pressure of combustion gas will not remarkably descend in this structure. The problem of ring suspension and pressure release in the first ring land can be resolved. Two types of rings with complete seal and economizing energy design are showed for the structure of one ring, which will also avoid the increase of end gap after the rings are worn.

Optimization of Piston-Ring System for Reducing Lube Oil Consumption by CAE Approach

Study on Analysis of Ring-Pack Lubricating Oil Consumption and Improved Design

Study on the influence of piston ring assembly structure on lubricating oil consumption and optimization design

Hybrid digital twin for conditional lubricant oil transport simulation and oil consumption prediction in internal combustion engines

Sequential Multi-Objective Optimization for Lubrication System of Gasoline Engines with Bilevel Optimization Structure

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

Design Approach for Optimization of a Piston Ring Profile Considering Mixed Lubrication

Lubricating Simulation Analysis of Connecting Rod Bearing Based on AVL-EXCITE

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Optimizing Oil Distributor Port for Low-Pulsation Cam-Lobe Hydraulic Motors

Tribological Design of the Running-in Process

Combined experimental and simulative approach for friction loss optimization of DLC coated piston rings

Simulation analysis and performance optimization of the combustion process of the opposed cam piston engine

A New Numerical Method for Piston Dynamics and Lubrication Analysis

Investigation of the Lubrication System in a Vehicle Axle: Numerical Model and Experimental Validation

A new efficient flow continuity lubrication model for the piston ring-pack with consideration of oil storage of the cross-hatched texture

A New Method to Reduce Frictional Power Consumption of Piston Ring in Internal Combustion Engine

Geometry design and optimization of piston by using finite element method

Optimizing The Shape Of Top Piston Ring Face Using Inverse Method

Tribological Simulation and Design of Piston Skirt- Liner System to Reduce Friction of Automotive Engines

Study of the Piston System Structure of Advantageous to Low Friction and Economizing Energy