Abstract:The interaction mechanism between the tool flank wear and the cutting force, in milling Ti-6Al-4V, is of significance for its further development. However, the relationship between the tool flank wear and the cutting force should be further investigated under ultrasonic-assisted milling. In this study, the longitudinal-torsional ultrasonic-assisted milling (LTUAM) Ti-6Al-4V in dry cutting was evaluated by comparing with conventional milling (CM). With the consideration of the ultrasonic vibration on the chip flow angle, a novel cutting force model in terms of the tool flank wear was developed by discretizing the side edge to apply the oblique model. Wherein the stress evolution both on the shear plane and the flank plane was analyzed, as well as the swinging range of chip flow angle resulted from ultrasonic vibration. In addition, the coefficients of the cutting force were calibrated through the mechanical method. The model could predict the cutting force evolution with different flank wear bandwidth (VB), and optimize the machining parameters. The experimental results indicated the errors between the model and the test were 19.1 % and 12.9 % in the feed (x) and the normal (y) direction of the tool coordinate system (o-xyz), respectively. Through time-frequency transformation, the behavior of the cutting force both in CM and LTUAM was further explained. Besides, the growing amplitude was beneficial to restrain the flank wear apart from the overgrowing amplitude, while the growing helix angles resulted in the serious tool flank wear in LTUAM. For the machined surface texture, the cutter scratches parallel to the feed direction dominated the machined surface in CM while the LTUAM surface featured by the order wave textures.

Study on the Thrust Cutting Force in Ultrasonic Elliptical Vibration Cutting

Study of machining accuracy in ultrasonic elliptical vibration cutting

Suppression of burrs in turning with ultrasonic elliptical vibration cutting

Modeling of the Effects of Phase Shift on Cutting Performance in Elliptical Vibration Cutting

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Effect of Vibration Parameters on Ultrasonically Elliptical Vibration Cutting

Simulation and Experiment of Cutting Force in Ultrasonic Torsional Vibration Assisted Micro-Milling

A STUDY ON THE IMPROVEMENT OF MACHINING SYSTEM STABILITY BY APPLYING ULTRASONIC ELLIPTICAL VIBRATION CUTTING

Analysis of Regenerative Chatter Suppression with Adding the Ultrasonic Elliptical Vibration on the Cutting Tool

Modeling of cutting forces in 1-D and 2-D ultrasonic vibration-assisted milling of Ti-6Al-4V

A Theoretical and Experimental Investigation of Thrust and Torque in Vibration Microdrilling

Study of milling force variation in ultrasonic vibration-assisted end milling

Study on thrust force of ultrasonic-assisted vibration micro-hole drilling of titanium alloy

Analytical modeling of cutting force in machining of SiCp/Al composites by ultrasonic elliptical vibration-assisted turning

Cutting Force Model of Longitudinal-Torsional Ultrasonic-Assisted Milling Ti-6Al-4V Based on Tool Flank Wear

Experimental and simulation investigation of ultrasonic elliptical vibration cutting of tungsten alloys in ultra-precision machining

Ultrasonic Elliptical Vibration Cutting for Weak Rigidity Workpiece

An Experimental Study on Cutting Forces in Ultrasonic Assisted Drilling

Force prediction in ultrasonic vibration-assisted milling

Optimization of cutting parameters in double-excitation ultrasonic elliptical vibration cutting of 630 stainless steel

Effect of Ultrasonic Vibration Parameters on Machining Performance Based on Tool-Workpiece Contact Ratio