Multidimensional ultrasonic vibration machining modeling of SiCp/Al cutting forces with different volume fractions: Experiments and numerical simulations
Daohui Xiang,Zhong Cheng,Zhaojie Yuan,Yanqin Li,Peicheng Peng,Chaosheng Song,Zhiqiang Zhang,Guofu Gao,Xiaobin Cui,Jinglin Tong
DOI: https://doi.org/10.1016/j.coco.2024.102022
IF: 8
2024-10-01
Composites Communications
Abstract:The cutting properties of the particles of aluminum-based silicon carbide (SiCp/Al) and the base material are so disparate that it is challenging to ensure the surface quality of machining. The cutting force significantly influences the quality of the machined surface. Therefore, real-time cutting force prediction is paramount for ensuring the workpiece's desired surface quality. This paper presents a 3D ultrasonic milling force model, established from four aspects: cutting formation force, extrusion friction force, SiC particle crushing force, and ultrasonic impact force. The model is based on the ultrasonic action of the cutting process and the unique removal characteristics of the material. A 3D ultrasonic milling system was constructed to experimentally verify the milling force model. The effects of each parameter on the milling force were analyzed through orthogonal experiments, which resulted in the effects of depth of cut, rotational speed, volume fraction, ultrasonic amplitude, and feed rate. The ultrasonic amplitude, feed rate, and other factors were found to influence the milling force to varying degrees. The milling force was observed to be 42.47 %, 22.37 %, 10.85 %, 12.67 %, and 11.64 % affected by the factors mentioned above, respectively. The single-factor experiment was conducted to analyze the cutting force at different machining parameters. The experimental results and the MATLAB numerical simulation results exhibited a similar trend of change. The maximum absolute error between the two was 12.71 %, with an average absolute error of 3.735 %.
materials science, composites