Abstract:The central element of a phased array antenna that performs beam electrical scanning, as well as signal transmission and reception, is the transceiver (T/R) module. Higher standards have been set for the integration, volume, power consumption, stability, and environmental adaptability of T/R modules due to the increased operating frequency of phased array antennas, the variability of application platforms, and the diversified development of system functions. Device-based multichannel T/R modules are the key to realizing low-profile Ka-band phased array antenna microsystem architecture. The design and implementation of a low-profile, high-performance, and highly integrated Ka-band phased array antenna T/R module are examined in this paper. Additionally, a dependable Ka-band four-channel T/R module based on Si/GaAs/Low Temperature Co-fired Ceramic (LTCC), applying multi-material heterogeneous integration architecture, is proposed and fabricated. The chip architecture, transceiver link, LTCC substrates, interconnect interface, and packaging are all taken into consideration when designing the T/R module. When compared to a standard phased array antenna, the module's profile shrunk from 40 mm to 8 mm, and its overall dimensions are only 10.8 mm × 10 mm × 3 mm. It weighs 1 g, and with the same specs, the single channel volume was reduced by 95%. The T/R module has an output power of ≥26 dBm for single-channel transmission, an efficiency of ≥25%, and a noise factor of ≤4.4 dB. When compared to T/R modules based on System-on-Chip (SOC) devices, the RF performance has significantly improved, as seen by an increase in single channel output power and a decrease in the receiving noise factor. This work lays a foundation for the devitalization and engineering application of T/R modules in highly reliable application scenarios.

R&D of RF-IF amplifier subassembly with STC

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Design and Fabrication of a TR Microsystem in Ka Band with Si-Based 3D Heterogeneous Integration

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

Substrate Integrated Waveguide Based Class‐f Power Amplifier

The design of precision digital STC attenuation subassembly

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

Development of a digital low-level RF system for the STCF

Large Bandwidth RGC Transimpedance Preamplifier Design in SCA

Design Of Rf Amplifier With Tunable Active Inductor

Design of a Ka-Band Heterogeneous Integrated T/R Module of Phased Array Antenna

1.3 GHz 20 Kw Solid State Amplifier for DC-SRF Photoinjector at Peking University

An RF Amplifier with High-PSRR Active Inductor

Radio Frequency Measurements and Tuning of the China Material Irradiation Facility RFQ

Low-Level Radio-Frequency system integrated with feed-forward control and vector modulation

Prototype design of a digital Low-Level RF system for S3FEL S-band Transverse Deflecting Cavities

A 2.5D Integrated L Band Receiver Based on High Resistivity Si Interposer

Design of a Low Level Radio Frequency Control System for the Direct Current-Superconductive Photocathode Injector at Peking University

A demonstration HTS base station sub-system for mobile communications

Front-end frequency conversion module design for harmonic RF system in SSRF

Design and Implementation of an RF Power Amplifier Used in Nuclear Magnetic Resonance Spectrometer