Abstract:This paper presents an analysis and design of a load-independent (LI) series resonant (SR) power amplifier with constant current (CC) output, along with its application for an MHz wireless power transfer (WPT) system. A novel inverse Class E power amplifier is introduced, which essentially produces a sinusoidal output current even with a low-$\bm Q$ SR filter. Besides, the proposed amplifier achieves zero-current switching (ZCS) and CC output simultaneously, regardless of the load resistance. The LI operation is obtained for a specific set of component values, whose design conditions are clarified analytically in this paper. The experiment was carried out with a WPT system incorporating the proposed amplifier as a transmitter and the Class D rectifier as a receiver. Although the input reactance of the Class D rectifier changed against DC-load variations due to the parasitic capacitances, the proposed amplifier showed consistent CC operation by using the low-$\bm Q$ SR filter. Also, the proposed WPT system maintained a low total harmonic distortion (THD) of the transmission current over the wide load range, even with the low-$\bm Q$ output filter. The prototype WPT system with the proposed amplifier achieved 88 % power-delivery efficiency with 60 W output power at 3.39 MHz transmission frequency. The experimental results showed the effectiveness of the proposed amplifier.

An RF Amplifier with High-PSRR Active Inductor

Design Of Rf Amplifier With Tunable Active Inductor

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

An Inductorless 5-GHz Differential Dual Regulated Cross-Cascode Transimpedance Amplifier using 40 nm CMOS

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Radio‐frequency Amplifier with Tunable High‐q RF Bandpass Filtering for SAW‐less Wireless Receivers

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

R&D of RF-IF amplifier subassembly with STC

A 0.03-3GHz Wideband Inductorless Receiver in 65nm CMOS

A 0.18um CMOS Using High-Q Active Inductors for Multi-band Low Noise Amplifier

A 8.1 Mw 0.1∼2 GHz Inductorless CMOS LNTA for Software-Defined Radio Applications.

A dual band CMOS two-stage variable gain low noise amplifier

Analysis and Design of Load-Independent Series Resonant Power Amplifier With Constant Current Output and Its Application for WPT System

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A Cmos Multi-Band Low Noise Amplifier Using High-Q Active Inductors

Co-design of an Auxiliary Self-Bias Module and a CMOS Rectifier for RF Energy Harvesting

S-Band Low Power Consumption Amplifier For Rfid Applications