Abstract:Hydrogen peroxide (H 2 O 2 ) synthesis via the electrocatalytic reduction of oxygen is a sustainable alternative to the energy-intensive anthraquinone oxidation process. The use of gas diffusion electrodes in dual membrane electrode assembly (MEA) solid electrolyte (SE) electrolyzers has substantially improved H 2 O 2 production, but the influence of mass transport and local reaction environment on H 2 O 2 performance in these cell architectures is still unclear and unoptimized. Herein, we investigate the impacts of electrode components and reactor operating conditions on the H 2 O 2 performance and cell potential required to reach current densities up to 400 mA cm −2 . Results show an intermediate catalyst loading of 2 mg cm −2 improves H 2 O 2 production through balancing O 2 diffusion and active site exposure. Hydrophobic treatment via fluoropolymer improves electrode stability, but addition of >15 wt% fluoropolymer worsens performance, likely by limiting active site accessibility at the catalyst-membrane interface. Moreover, decreasing O 2 concentration from typical pure streams to match the composition of air has a negligible effect at moderate current densities (∼50 mA cm −2 ), but significantly impacts overall performance at higher current densities (∼200 mA cm −2 ). This work also highlights benefits of operating the reactor with a recycled product stream rather than tuning the flow rate of water over the SE to extremely low values to obtain high H 2 O 2 concentrations, as the latter likely contributes to exacerbated H 2 O 2 degradation in the electrolyzer. This work provides insights into how macroscale system properties in flow cell electrolyzers impact the local reaction environment and mass transport, which in turn dictate overall catalytic performance.

Electrolytic Hydrogen Evolution in DMFCs Induced by Oxygen Interruptions and Its Effect on Cell Performance

Effect of Transient Hydrogen Evolution∕Oxidation Reactions on the OCV of Direct Methanol Fuel Cells

Electrochemical Reactions in a DMFC under Open-Circuit Conditions

Modeling of Spontaneous Hydrogen Evolution in a Direct Methanol Fuel Cell

A Study of the Direct Dimethyl Ether Fuel Cell Using Alkaline Anolyte

Influence and Mechanism of Dissolved Oxygen on the Performance of Ammonia-Oxidation Microbial Fuel Cell

Oxygen Starvation Induced Cell Potential Decline and Corresponding Operating State Transitions of a Direct Methanol Fuel Cell in Galvanostatic Regime

In-situ Investigation and Modeling of Electrochemical Reactions with Simultaneous Oxygen and Hydrogen Microbubble Evolutions in Water Electrolysis

Abrupt Decline in the Open-Circuit Voltage of Direct Methanol Fuel Cells at Critical Oxygen Feed Rate

Depression of Hydrogen Evolution During Operation of A Direct Borohydride Fuel Cell

Local reaction microenvironment impacts on H 2 O 2 electrosynthesis in a dual membrane electrode assembly solid electrolyte electrolyzer

Effect of methanol crossover on the cathode behavior of a DMFC: A half-cell investigation

High-performance Microfluidic Electrochemical Reactor for Efficient Hydrogen Evolution

Effects Of Anode Diffusion On Direct Methanol Fuel Cell (Dmfc) Performance

Understanding the Performance Degradation of Anion-Exchange Membrane Direct Ethanol Fuel Cells

Experimental Measurements of Fuel and Water Crossover in an Active DMFC

In situ investigation on ultrafast oxygen evolution reactions of water splitting in proton exchange membrane electrolyzer cells

Effect of cathode gas flow patterns on performance of micro direct methanol fuel cell

Anode reaction mechanism and crossover in direct dimethyl ether fuel cell

Addition of Non-Reacting Gases to the Anode Flow Field of DMFCs Leading to Improved Performance

Electrochemical performance and microstructural characterization of solid oxide electrolysis cells