Experimental Measurements of Fuel and Water Crossover in an Active DMFC
Xianglin Li,Zheng Miao,Lauren Marten,Isaac Blankenau
DOI: https://doi.org/10.1016/j.ijhydene.2020.11.027
IF: 7.2
2021-01-01
International Journal of Hydrogen Energy
Abstract:This study measured polarization curves as well as the high-frequency resistance of active direct methanol fuel cell (DMFC) operates at around 80 degrees C with active controls of temperature, methanol concentration, airflow rate, and relative humidity. The relative humidity of the air did not have noticeable impacts on the fuel cell unless the operating temperature was near the evaporation temperature of water (100 degrees C). The hydrophobic water management layer (WML) between the membrane electrode assembly (MEA) and cathode air channel increases the mass transfer resistance and improves the water retention in MEA. Adding a WML increased the peak power density, decreased the ohmic resistance, and improved the fuel efficiency of the fuel cell, especially when it operated near 100 degrees C. This study also quantitatively measured methanol and water crossover as well as the fuel efficiency at different operating currents. The fuel efficiency increased significantly with the increase of the current density. Using a hydrophobic fuel management layer (FML) between the anode fuel channel and MEA reduced the fuel and water crossover rates and increased the ohmic resistance due to the decrease of the water content of the Nafion membrane. The FML improved fuel efficiency by reducing the methanol crossover. The combination of the FML and WML enabled the steady operation of DMFC using highly concentrated methanol solutions (up to 75 wt%). (C) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.