Abstract:In response to the development of low-carbon smelting technology, reducing the use of fluor-containing materials in desulfurizers is an important research topic. The development of new-generation KR (Kambara Reactor) desulfurizers is shifting towards a higher Al2O3 content rather than CaF2, yet there is currently an absence of thorough and comprehensive mechanisms for desulfurization. Consequently, this research provides an extensive comparison using a specially constructed small-scale KR desulfurization hot model test, alongside FactSage simulation and SEM analysis (of desulfurization process). The findings indicate that at 1400 °C, for the desulfurization of molten iron, the capacity for desulfurization initially increases and then diminishes as the Al2O3 content in the KR desulfurizer rises. With Al2O3 content in the desulfurizer below 22 wt.%, the phase composition predominantly consists of C3A, employing a solid(slag)–liquid(metal) diffusion method for desulfurization. The optimal desulfurization capacity (Ls: 64.1) is observed when the Al2O3 content is 15 wt.%, attributed to the simultaneous presence of CaO particle precipitation and C3A. However, as the Al2O3 content reaches 20 wt.%, all the oversaturated CaO integrates into C3A, leading to a reduction in Ls from 64.1 to 10.7, thereby diminishing the desulfurization capacity by approximately sixfold. When Al2O3 exceeds 22 wt.%, the phase composition transitions from the C3A to C12A7 phase, and the desulfurization approach shifts from solid(slag)–liquid(metal) to liquid(slag)–liquid(metal) diffusion, with Ls decreasing to 23.4. This reduction is due to C12A7's lower sulfur capacity compared to C3A and the absence of saturated CaO particle precipitation. Therefore, for Al2O3 to effectively replace fluorite in KR desulfurizers, a higher presence of C3A phases and CaO particle precipitation are essential. The desulfurizer must contain over 65 wt.% CaO and maintain Al2O3 levels at 10~16.2 wt.%.

Effect of Calcium Oxide Additive on the Performance of Iron Oxide Sorbent for High-Temperature Coal Gas Desulfurization

Experimental Study of Desulfurization of Chemical-Loping Combustion of Coal With Calcium-based Oxygen Carrier

A Study of High Temperature Desulfurization and Regeneration Using Iron-Calcium Oxides in a Fixed-Bed Reactor

Study on desulfurization reaction characteristic of calcium-based sorbents

Desulfurization performance of iron-manganese-based sorbent for hot coal gas

Experimental Study on Preparation of Calcium Oxide by Coal Reduction of Calcium Sulfate in Carbon Dioxide Atmosphere

The Effect of Metallic Salt Additives on Calcium-Based Desulfurization in O_2-CO_2 Pulverized Coal Combustion

Studies on additives of high-temperature CAO sulfation

Study on the Stability of Sorbents Removing H2S from Hot Coal Gas

Study on SO2 removal of calcium sorbent mixed with pulverized coal ash

Effect of water content on desulfurization characteristic of calcium-based sorbent

Two-Stage Desulfurization Of Calcium-Based Sorbents During Coal Combustion In The Chain-Grate Furnace

Influence of Dust on High Temperature Desulfurization of Iron Oxide Sorbent

Desulfurization Characteristic of Calcium-Based Sorbent During Activation Process.

Effect of impurities on desulfurization properties of limestone during coal gasification

Desulfurization Behavior of Cerium–Iron Mixed Metal Oxide Sorbent in Hot Coal Gas

Removal of sulfur at high temperatures using iron-based sorbents supported on fine coal ash

Effects of additives on preparation and use of calcium sorbent for SO_2 removal

Sulfation Performance of CaO under Circulating Fluidized Bed Combustion-Like Condition

Desulfurization Characteristic of Organic Calcium at High Temperature

Effects of Different CaO/Al2O3 Ratios on the Phase Composition and Desulfurization Ability of CaO-Based Desulfurizers in Hot Metal