Microstructure and mechanical properties of ADC12 aluminum alloy under super slow speed die castings with low shot speed

JI Lian-qing,GUO Chang-jiang,XIONG Shou-mei,LIU Kun

2010-01-01

Abstract:Influences of low shot speed under die casting process of super slow speed(SSS) on microstructure and mechanical properties of ADC12 aluminum alloy were investigated in order to optimize SSS die casting process and parameters. Optical microscope,scanning electron microscope,X-ray diffractrometry and energy spectrum were taken to measure the microstructure and mechanical properties of this material. Compared with die castings under both producing conditions of different low-shot speeds at the same start position of high-speed injection stage and different start positions of high-speed injection stage at the same low-shot speed,the effect of low shot speed on casting density in the die casting process of the super slow speed is not obvious. With the increase of low-shot speed,α(Al) branches of this castings becomes larger and larger and its mechanical properties decrease at the same start position of high-speed injection stage. The optimized value of the start position of high-speed injection stage exists at the same low speed,and α(Al) branches are very small and the properties of castings are better at the start position of 260 mm.