Abstract:The proposed radio‐frequency receiver is a low‐IF receiver architecture, not a zero‐IF Rx, with the IF frequency being twice the channel bandwidth, that is, the intermediate frequency in the RF receiver equals 200 MHz. The radio‐frequency receiver consists of a low‐noise driver stage (RF stage) and an in‐phase/quadrature of phase (I/Q) demodulator. The low‐noise driver stage is designed using a complementary current‐reuse common‐gate configuration with shunt feedback to achieve wideband RF input matching with ultra‐low power dissipation, enhancing linearity compared to the conventional configuration. Summary This paper presents a battery‐free ultra‐low‐power (ULP), highly integrated, and wide‐bandwidth low‐IF radio‐frequency (RF) receiver designed for millimeter‐wave (mm‐Wave) applications, utilizing 130‐nm CMOS technology. The suggested RF receiver is suitable for K‐band (n258) at 26 GHz, Ka‐band (n261 and n257) at 28 GHz, and the LMDS band at 28 GHz in fifth‐generation applications. The proposed radio receiver consists of a low‐noise driver stage implemented using a complementary current‐reuse common gate with an active shunt feedback configuration and an in‐phase/quadrature‐phase (I/Q) demodulator. The proposed RF receiver employs transformer coupling to isolate the DC path between the transconductance stage (RF stage) and the switching stage (IF stage). The driver stage expands the RF input impedance while maintaining acceptable linearity and gain with ultra‐low DC power dissipation. The DC supplies for the proposed mm‐Wave RF receiver are generated using two novel energy‐harvesting voltage doubler circuits to provide positive and negative voltages. The proposed mm‐Wave radio receiver consumes 0.475 mW from a 1.1 V DC supply and exhibits a power conversion gain (CG) of 6.3 dB, with a 3 dB frequency bandwidth extending from 22 to 32 GHz. The input 1‐dB compression point (P1dB) of the RF receiver is −2.65 dBm, and the input third‐order intercept point (IIP3) is 7.35 dBm. With a sensitivity of −66.5 dBm at a 100 MHz channel bandwidth and a dynamic range of 63.85 dB, the suggested receiver demonstrates notable performance characteristics. The proposed radio receiver boasts an excellent figure of merit (FoM) at 215 dB, surpassing published works by a margin of 8–31 dB. The primary positive supply voltage is derived from a double‐band positive voltage doubler with series resonance feedback and parallel resonance networks, efficiently achieving the desired DC voltage and output current (1.1 V and 450 μA). Meanwhile, the negative gate bias is provided by a negative voltage doubler, ensuring the necessary negative voltage (−0.5 V) without any current conditions.

Cmos Low-Power Analogue Baseband Circuits for a Non-Coherent Low Data Rate IR-UWB Receiver

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Low power high data rate GHz range receiver in 40nm CMOS technology

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

Design Considerations for Low-power IR-UWB Receiver and LNA

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A Low Power 35 Ghz Cmos Uwb Receiver Front-End

An Ultra Low-Power Dual-Band IR-UWB Transmitter in 130-nm CMOS

A CMOS Ultra Low-Power and Highly Efficient UWB-IR Transmitter for WPAN Applications

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

An 89 Μw MICS/ISM Band Receiver for Ultra-Low-power Applications.

A 0.5–15 GHz Reconfigurable IR-UWB Receiver in 28 Nm CMOS

CMOS UWB IR Non-Coherent Receiver for RF-ID Applications

A Low-Power and Flexible Energy Detection IR-UWB Receiver for RFID and Wireless Sensor Networks

An Energy Detection Receiver for Non-Coherent IR-UWB

0.15-Nj/b 3–5-Ghz IR-UWB System with Spectrum Tunable Transmitter and Merged-Correlator Noncoherent Receiver

Battery‐free ultra‐low‐power radio‐frequency receiver for mm‐wave applications using 130‐nm CMOS technology with harvested DC supplies

A 132 Mb/s, 1bit 4224 M Samples/s Sub-Sampling, Low-Complexity and Energy-Efficient BPSK Transceiver for All-Digital 3–5 GHz IR-UWB

A CMOS RSSI for OFDM-UWB Receiver

A non-coherent receiving solution for near field pulse UWB communication