Abstract:A 0.5-15 GHz ultra-wideband (UWB) RF reconfigurable receiver in UMC 28 nm CMOS used for IR-UWB (impulse radio UWB) radar system is proposed in this paper. This receiver employs a 0.5-8 GHz path and an 8-15 GHz path to achieve the wide frequency band, and we proposed an RF channel select voltage-to-time converter (VTC) circuit. Two different low noise amplifiers (LNAs) are adopted in the two paths to obtain the high performance of noise figure (NF) and gain. The common drain stage and resistance negative feedback technology as well as the source degeneration inductive technology are introduced to achieve a high flat gain and fine input matching. The R-2R variable load network of a programable gain amplifier (PGA) gives it a nearly 24 dB dynamic range and approximately linear gain control. A 500MS/s time domain analog to digital converter (TD-ADC) with an equivalent sampling rate of 16GS/s is shared for the two paths which can realize the direct RF sampling. The input RF signal path selection is implemented by configuring the Band_sel signal. The receiver has reconfigurability of the RF front end and better power consumption and area. In the frequency of 0.5-8 GHz, the S11 is below -7.9 dB and the NF is smaller than 6 dB. In the frequency of 8-15 GHz, the S11 is below -8dB and the NF is smaller than 11 dB. The receiver dissipates 242.72mW with an area of 1.01 mm2

An Energy Detection Receiver for Non-Coherent IR-UWB

A non-coherent receiving solution for near field pulse UWB communication

A Low-Power and Flexible Energy Detection IR-UWB Receiver for RFID and Wireless Sensor Networks

A Flexible Energy Detection IR-UWB Receiver for RFID and WSN

A Digital Back-End of Energy Detection UWB Impulse Radio Receiver

Impulse UWB Energy Detection Receiver with Energy Offset Synchronization Scheme

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Design Considerations for Low-power IR-UWB Receiver and LNA

A Study on Performance of an IR-UWB Receiver Based on Energy Detection

Weighted Non-Coherent Energy Detection Receiver for UWB OOK Systems

Cmos Low-Power Analogue Baseband Circuits for a Non-Coherent Low Data Rate IR-UWB Receiver

A Flexible Back-End with Optimum Threshold Estimation for OOK Based Energy Detection IR-UWB Receivers

A Radio UWB System for Sensor Network Application

A Low Power Interference Robust IR-UWB Transceiver SoC for WBAN Applications

CMOS UWB IR Non-Coherent Receiver for RF-ID Applications

A 0.5–15 GHz Reconfigurable IR-UWB Receiver in 28 Nm CMOS

A Low-Complexity UWB RF Receiver Based on a Novel Low Noise Amplifier

Adaptive Synchronization and Integration Region Optimization for Energy Detection IR-UWB Receivers.

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A high efficiency robust IR-UWB receiver design for high data rate CM-range communications

Analog Front-End RX Design for UWB Impulse Radio in 90nm CMOS.