Abstract:Industrialization has led to an increasing need for specific and selective gas sensors in the past few decades. Environmental monitoring of certain volatile compounds such as ammonia is necessary. Advancements in the food storage sector have created the need for cheap and effective amine chemosensors. Classical chemosensors still face several issues, such as a lack of selectivity and low sensitivity toward ammonia and amines. Sensitivity is defined as the relative change in response expressed in percentage. In this work, we have resolved a few issues associated with the ammonia and amine sensors, such as low selectivity, long-term instability, and unreliability under higher temperatures using plasma-polymerized thiophene (PPTh) reduced graphene oxide (rGO) composite films. PPTh films were prepared using RF plasma polymerization with optimized deposition parameters. Several samples were evaluated for their sensing response to understand the optimal PPTh and rGO ratio in the PPTh-rGO composite. These composite PPTh-rGO films have shown 4 times higher sensitivity for ammonia/amines than individual PPTh and rGO films. Ammonia, methylamine (MA), dimethylamine (DMA), and trimethylamine (TMA) were primary analytes and tested for sensing response of the PPTh-rGO composite. The sensitivity measured ranges from 1328 for trimethylamine to 2354 for methylamine at 1000 ppm. The order of sensitivity was found to be MA > Ammonia > DMA > TMA. Polymer swelling, reduced charge carriers, and disruption of conductive pathways can explain possible sensing mechanisms. PPTh-rGO composite films have shown selectivity as high as 110 for ammonia/amine over other commonly used volatile organic compounds. The sensing response of these films is stable for any temperature fluctuations from 30 °C to 150 °C. Additionally, films showed stable sensitivity for over 4 months. Thus, composite films of PPTh-rGO can be effectively used to develop highly selective and stable gas sensors for the environmental monitoring of ammonia/amines.

Evaluation of Polymer Coatings for Ammonia Vapor Sensing with Surface Plasmon Resonance Spectroscopy

Screening of Polymer Coatings for Surface Plasmon Resonance Sensing of Ammonia Vapor

The Research and Application of Polyaniline/Multi-Walled Carbon Nanotubes Composite Sensitive Membrane for Ammonia Gas Detection

Strategic Approach for Enhancing Sensitivity of Ammonia Gas Detection: Molecular Design Rule and Morphology Optimization for Stable Radical Anion Formation of Rylene Diimide Semiconductors

Sensors for Organic Vapor Detection Based on Composites of Carbon Nonotubes Functionalized with Polymers

Polymer Film Coated Micro/Nanofiber for Gas Sensing

Facile, Low‐Cost and Flexible Ammonia Sensor Arrays Based on Metallic Ion Charge Carriers and Polymer Matrices

Highly Sensitive NH3 Gas Sensors Based on Novel Polypyrrole-Coated SnO2 Nanosheet Nanocomposites

In Situ Prepared Composite of Polypyrrole and Multi-Walled Carbon Nanotubes Grafted with Sodium Polystyrenesulfonate As Ammonia Gas Sensor with Wide Detection Range

Fabrication and Ammonia Gas Sensing of Palladium/polypyrrole Nanocomposite

Fabrication of Reproducible and Selective Ammonia Vapor Sensor-Pellet of Polypyrrole/Cerium Oxide Nanocomposite for Prompt Detection at Room Temperature

Development of ammonia sensors by using conductive polymer/hydroxyapatite composite materials

A Polymer‐Based Chemiresistive Gas Sensor for Selective Detection of Ammonia Gas

Highly Ammonia Sensing Using Direct In Situ Electro-Deposited Polypyrrole-Dodecylbenzene Sulfonic Acid Film on ITO Coated Flexible Substrates

Porous Polypyrrole/Polymethylmethacrylate Composite Film Prepared by Vapor Deposition Polymerization of Pyrrole and Its Application for Ammonia Detection

Plasma-Polymerized Thiophene-Reduced Graphene Oxide Composite Film Sensor for Ammonia/Amine Detection at Room Temperature

Functional Polymeric Membranes with Antioxidant Properties for the Colorimetric Detection of Amines

Characterization of the gas sensors based on polymer-coated resonant microcantilevers for the detection of volatile organic compounds.

Highly Sensitive and Selective Surface Acoustic Wave Ammonia Sensor Operated at Room Temperature with a Polyacrylic Acid Sensing Layer.

A Highly Sensitive Ammonia Sensor Based on Spinous Core–shell PCL–PANI Fibers

Ammonia detection using nanoporous alumina resistive and surface acoustic wave sensors