Abstract:With the advent and development of power semiconductor switches like IGBT or MOSFET, high-speed switching devices have sprung up and sped up dynastic response of converters. However, these devices in operation will produce very large dv/dt and di/dt, which result in sever electromagnetic interference(EMI). In a variable-frequency drive(VFD) system, due to the coupling common-mode(CM) noise, communication between programmable logic controller(PLC) and VFD will be affected by CM current at the motor side if communication cables get too close to the motor ones. This paper emphatically analyzes the effect of common-mode interference on communication performance of a motor drive system. It introduces the generation mechanism of CM voltage and current at the motor side in a VFD system first and briefly illustrates how it couples to the communication cables. At the same time, some certain influence factors of CM current in communication system are respectively explained. Then it elaborates the detailed mechanism how CM current on communication cables affects the error rate which is employed to evaluate the communication quality. Besides, the numerical relationship between CM current on communication cables and the error rate is also discussed and confirmed by series of experiments. Finally, some software or hardware solutions are put forward to achieve the aim of interference suppression and decreasing the error rate when CM current on communication cables is constant.

Design of Anti-Interference for Electrical Control System of Knitting Machine

Research of Anti-Interference Technology for the Open-Architecture Shoe Last NC Machine

Precise Control of Needle Position of the High-Speed Flat Sewing Machine

Design of Embedded Control System in Computerized Flat Knitter Based on ARM

Design of Low-cost Electronic Jacquard Controller

Design and Application of Distributed Control System for High Speed Paper Machine

Design of Reliability Detection System for Driving Circuit of Needle Selector of Circular Weft Knitting Machine

The Control System of Jacquard Loom Based on MCU

Design of a residual current circuit breaker IC with anti-interference technique

Design of the Software System of Automatic Flat Knitting Machine Based on Linux Embedded Technology

Development of the Control System of Automatic Flat Knitting Machine Based on Μc/os-ⅱ Embedded Technology

Design of Control System Using for Full Automatic Glove Knitting Machine

Design of Carpet-Knitting Machine Control System Based on Embedded System

Design of Anti-Interference Circuit of Computer Controlled Pipe Welding Robot

Research on the Anti-interference Measures forthe Control Sytem of the Computer Using in the Al-Elektrolyzing

The Design of Warp Tension Embedded Intelligent Control System Based on μC/OS and ARM

Optimization Design of Anti-Strong Magnetic Interference for Intelligent Miniature Circuit Breaker

Artificial Fur Knitting Machine Auto-Control System

Design of Control System of Loom Machine Based on ARM

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

Design of Control System of Computerized Embroidery Machine Based on DSP