Abstract:Due to their high specific strength and stiffness, stiffened thin-walled structures are extensively utilized in aerospace applications to maintain a high load-bearing capacity in a complex thermo-mechanical coupled environment. Thermal deformation significantly impacts the intake and exhaust performances, aerodynamic profiles, and even structural safety, hence how to design a reasonable stiffener layout for thermal structures is necessary. Thermoelastic topology optimization is an efficient method. However, to reduce the thermal load and maintain stiffness, design-dependent thermal loading problems such as the grayscale issues and the material-less effect often result. Due to the high proportion of gray elements and a lower penalized element stiffness, thermal deformation magnitude is closely related to the grayscale issues. Therefore, the key challenge is to address the grayscale issues induced by the thermal load. To address this challenge, a thermoelastic topology optimization method via regional strain energy minimization (RSEM) is proposed in this study. The region here means the skin domain of stiffened thin-walled structures. To control the width size of stiffeners consisting of voxels, a maximum size constraint is established through the p-mean aggregation function, employing the Helmholtz-type anisotropic filter to calculate the solid ratio. This study compares three optimization formulations that minimize the compliance, global strain energy and regional strain energy as objective functions, respectively. Two numerical examples are presented to demonstrate the effectiveness of the proposed method in addressing design-dependent thermal loading problems. Compared to conventional methodologies, the proposed method can generate a clear stiffener layout and reduce the thermal deformation by 77% for an engineered thin-walled end cap structure under a thermo-mechanical coupled field.

Thermal Stress Distributions and Optimization on Stress Reductions with Or/and Without Linearly Graded Interlayers

Thermal stress reduction of bilayered systems by means of linearly graded interlayer

Effectiveness Of Compositionally Linearly Graded Interlayers For Thermal Stress Reduction

Thermal Stress Analysis and Structural Design of AlxGa1−xN/GaN Epilayers Based on Si Substrate

Modeling Simplification for Thermal Mechanical Stress Analysis of TSV Interposer Stack

Plane strain and three-dimensional analyses for thermo-mechanical behavior of multilayered transversely isotropic materials

Response of Dynamic Interlaminar Stresses in Laminated Plates under Free Vibration and Thermal Load

Design and Mechanical Experiment of Functionally-Graded Lattice Structure with Multiple Loading Conditions

Experimental Analysis for Thermal Stress in Functionally Gradient Material

Optimum Designs for Multi-Layered Film Structures Based on the Knowledge on Residual Stresses

Thermal Stress Analysis of a Trilayer Film/substrate System with Weak Interfaces

Effect of Geometric Parameter on Thermal Stress Generation in Fabrication Process of Double-Ceramic-layers Thermal Barrier Coating System

Finite Element Analysis of Thermal Residual Stress in Ceramic Functional Graded Material: Interface Optimization for Residual Reduction

Thermal Stress Analysis of the Low-K Layer in a Flip-Chip Package

Numerical Analysis on Thermal Stress of Multilayer Materials Combined Structures for a Lightweight Thermal Protection System

Modeling of thermal residual stresses in multilayer coatings with graded properties and compositions

Thermal Stress Relaxation by A Composition-Graded Intermediate Layer

Thermal design of functionally graded cellular structures with multiple microstructure configurations through topology optimization

Thermal Stress in Functionally Graded Plates with a Gradation of the Coefficient of Thermal Expansion Only

Effect of Diffusion Interlayer and Graded Multi-Interlayers on the Reduction of Thermal Stress in Tritium Penetration Barrier Coating System

Thermoelastic topology optimization for stiffened thin-walled structures under design-dependent thermal loading problems