Inhomogeneity of Microstructure Evolution in Stir Zone of 2195al Thick-Plate FSW Joints
Yisong Gao,Huijie Liu,Shuaishuai Du,Quansheng Zhang,Dongrui Li,Yingying Zuo,Xuanmo Li
DOI: https://doi.org/10.1016/j.msea.2024.146265
IF: 6.044
2024-01-01
Materials Science and Engineering A
Abstract:An appropriate friction stir welding (FSW) tool has been developed to perform high-quality joining of 12 mm thick Al-Li alloy plates. Threads and triple facets were machined on the stirring pin to improve the material flow. The differences in microstructure characteristics, recrystallization mechanisms, and precipitate evolution along the stir zone (SZ) thickness were systematically clarified. The results indicated that microstructures in SZ were refined by dynamic recrystallization (DRX) and showed an apparent top-to-bottom gradient distribution in grain size. The geometric topology of the stirring pin results in periodic ultrafine-grained bands throughout SZ. At the top and middle regions of SZ, high-density vacancies and dislocations were formed due to elevated temperature and strain rate, facilitating the precipitation of T 1 (Al 2 CuLi) phases through a dislocation-induced heterogeneous nucleation mechanism. In comparison, icosahedral quasi-crystalline T 2 (Al 6 Cu(Li, Mg) 3 ) phases, which can be attributed to the segregation of atoms and high cooling rate, were detected along grain boundaries at SZ-bottom. Furthermore, the ultimate strength values of tensile specimens sectioned from the top, middle, and bottom parts of SZ are 452, 457, and 406 MPa, respectively. Studying the inhomogeneous microstructure and properties of welded joints provides a theoretical basis for manufacturing high-load components.