Monte Carlo Simulation of Determining Porosity by Using Dual Gamma Detectors

ZHANG Feng,LIU Jun-tao,YUAN Chao,JIA Yan,YU Hua-wei
DOI: https://doi.org/10.7538/tws.2013.26.02.0104
2013-01-01
Abstract:Current formation elements spectroscopy logging technology utilize 241Am-Be neutron source and single BGO detector to determine elements contents.It plays an important role in mineral analysis and lithology identification of unconventional oil and gas exploration,but information measured is relatively limited.Measured system based on 241Am-Be neutron and dual detectors can be developed to realize the measurement of elements content as well as determine neutron gamma porosity by using ratio of gamma count between near and far detectors.Calculation model is built by Monte Carlo method to study neutron gamma porosity logging response with different spacing and shields.And it is concluded that measuring neutron gamma have high counts and good statistical property contrasted with measuring thermal neutron,but the sensitivity of porosity decrease.Sensitivity of porosity will increase as the spacing of dual detector increases.Spacing of far and near detectors should be around 62 cm and 35 cm respectively.Gamma counts decrease and neutron gamma porosity sensitivity increase when shield is fixed between neutron and detector.The length of main shield should be greater than 10 cm and associated shielding is about 5 cm.By Monte Carlo Simulation study,the result provides technical support for determining porosity in formation elements spectroscopy logging using 241Am-Be neutron and gamma detectors.
What problem does this paper attempt to address?