Abstract:Abstract Important hydrocarbon accumulations occur in tight rocks in Colombian areas. Those tight reservoirs consist of clean sandstones with matrix porosities in the 3% to 4% range, relatively complex mineralogy and naturally fractured. The success of achieving a representative formation evaluation relies on obtaining accurate porosity, oil, gas, water saturations, natural fractures detection and good estimates on reservoir permeability. Resistivity-based approaches are difficult to apply since reservoir conductivity is not only influenced by fluid type, but also by salinity (typically low in our reservoirs), variable tortuosity (mostly high in the matrix and very low in fractures) and very high formation resistivity (above 1,000 ohms.m). In addition, a combination of low pores volumes and a matrix not properly assessed, leads to high errors in the porosity determination with conventional logs (in a 3 – 4 p.u. reservoir, the porosity error computation can be as high as 50%). Uncertainties in porosity estimates also translates to uncertainties during saturation assessment. Further challenges are found when attempting the saturation computation from resistivity logs. The tight sands are drilled with Oil Based Muds, creating a logging environment where only induction logs are possible. However, since the resistivity range in these rocks is above 1000 ohm.m range, the induction measurements are out of range in many of the target zones. Alternative formation evaluation methods for assessing fluids saturations, like magnetic resonance, sigma and carbon-oxygen logs cannot be applied below 10 porosity units; whereas dielectric measurements strongly depend on accurate porosity computations for deriving the hydrocarbon volume. Some of these reservoirs, are also deep (in the 17,000 ft range) and close to foothills, where wellbore stability issues and narrow mud weight windows used for drilling, translates into higher risks for open-hole logging via logging while drilling or wireline conveyance, all of it detrimental to data acquisition in open hole. Therefore, the case studies presented in this paper were assessed in cased hole conditions. In this paper, we present a solution that cover tight matrix and natural fractures assessment, at a level not previously achieved. At the tight matrix level, we carry out advanced nuclear spectroscopy with a new pulsed neutron device, that carry out simultaneous time domain and energy domain measurements. A new resistivity and salinity independent methodology for obtaining Gas saturation from a new measurement in the industry known as "Fast Neutron Cross Section" (FNXS), oil saturation from the total organic carbon (TOC) log, mineral volumes solved from formation elemental concentrations from energy domain, and porosity from hydrogen index obtained from the spectroscopy time domain, is presented. At natural fracture level, we make use of a Borehole Acoustic Reflection Service for deep natural fracture detection and spatial orientation analysis, done at cased hole conditions. The main advantages of the new method for obtaining porosity, mineralogy, salinity-independent hydrocarbon saturation in tight matrix and natural fracture assessment behind casing are: 1) conversion of dry weight total carbon to oil saturation, and fast neutron cross section to gas saturation done through a simultaneous inversion by solving matrix-porosity-fluids volumes into an elemental analysis, proven to work at low porosities rocks; 2) independency of salinity and reservoir tortuosity effects; 3) clay and/or other lithology effects is quantified and taken into account; 4) faster logging speeds and improve tools combinability in bigger holes while ensuring full reservoir assessment in small holes; 5) operational time reduction. The spectroscopy logging is carried out in single acquisition pass at 150 to 350-feet per hour (ft/hr), whereas sonic acquisition is done at 400 ft/hr in a single pass as well.

Simulations of absolute porosity measurements by compensated neutron logging tools mounted with stilbene or CLYC scintillators

Cased Hole Solution with Fast Neutrons and Sonic Reflective Waves in Tight Reservoirs

Calculation of Porosity and CO2 Content in CO2-Bearing Gas Formations Based on Density and Neutron Logging Forward and Inverse Methods

The Role of the Spatial Heterogeneity and Correlation Length of Surface Wettability on Two-Phase Flow in a CO2-water-rock System

iSCAL for Complete Rock Characterization: Using Pore-Scale Imaging to Determine Relative Permeability and Capillary Pressure

Improving the accuracy of CO 2 sequestration monitoring in depleted gas reservoirs using the pulsed neutron-gamma logging technique

Simulation study on the radioactive logging responses in the spiral borehole

An intercomparison of the pore network to the Navier–Stokes modeling approach applied for saturated conductivity estimation from X-ray CT images

Simulation of nuclear magnetic resonance response based on 3D CT images of sandstone core

A new method for calculating bulk density in pulsed neutron-gamma density logging

Simulation of gas-water identification in sandstone hydrogen reservoirs based on pulsed neutron logging

New Insight Into Data Processing of Nuclear Magnetic Resonance Logging for Pore Structure Characterization in Tight Sandstone Reservoirs

Quantitative Characterization of Pore Structure of Carbonate Rocks Based on Micron-CT Technique and Its Seepage Simulation

Formation Evaluation Using NMR, Mud Gas, and Triple-Combo Data – A Norwegian Logging-While-Drilling Case History

Influencing mechanics and correction method of nuclear magnetic resonance measurement in igneous rocks reservoir

Probe Material Choice for Nuclear Magnetic Resonance Cryoporometry (NMRC) Measurements of the Nano-Scale Pore Size Distribution of Unconventional Reservoirs

Research on recognition of gas saturation in sandstone reservoir based on capture mode

Effect of saturated brine with high concentration on nuclear magnetic resonance (NMR) data in high-porosity sandstone reservoirs

Using Direct Numerical Simulation of Pore-Level Events to Improve Pore-Network Models for Prediction of Residual Trapping of CO2

Nanoscale Pore Structure Characterization and Permeability of Mudrocks and Fine-Grained Sandstones in Coal Reservoirs by Scanning Electron Microscopy, Mercury Intrusion Porosimetry, and Low-Field Nuclear Magnetic Resonance

First Application of LWD NMR and Quadrupole Sonic Measurements Derived Formation Evaluation in a Carbonate Reservoir in Sichuan Basin, China