Abstract:In this paper, the radio frequency (RF) magnetron sputtering (MS) method was utilized to fabricate multiple sets of the iron film samples under different sputtering powers. With the help of X-ray diffraction (XRD), scanning electron microscopy (SEM), atomic force microscopy (AFM) and vibrating sample magnetometer (VSM), how the sputtering power affected the structure, morphology and magnetic properties of the iron film was studied. XRD results showed that all Fe films have a polycrystalline bcc structure and (110) preferred orientation. According to the Bragg equation calculation, the larger the sputtering power, the larger the average grain size, which is consistent with the results of AFM particle size analysis. The main reason is that the sputtering power affects the grain growth mode. As the sputtering power increases, it gradually changes from a small island-like growth to a thick columnar growth. However, from the surface morphology and height profile, we saw that the iron film deposited under 230 W had the most uniform grain size distribution and the grain size was relatively small. This is why thin films deposited under this condition have the best soft magnetic properties. The saturation magnetization (Ms) reaches 1566 emu/cm3, coercivity (Hc) is 112 Oe, and squareness ratio (Mr/Ms) is 0.40. Therefore, iron film prepared under 230 W has good comprehensive properties (highest Ms, lower Hc and Mr/Ms) that provide an experimental basis for further thin film research work.

Enhancement of Structural and Magnetic Properties in Sputtered Half-Metallic Fe3o4 Films

Magnetic And Electric Properties Of Fe3o4 Thin Films Sputtered On Metallic Underlayer

Soft Magnetism and Microwave Magnetic Properties of Fe-Co-Hf Films Deposited by Composition Gradient Sputtering

Magnetic Properties of Sputtered Fe1−xO and Fe+Fe3O4 Thin Films

Improvement of magnetic property of L10‐FePt film by FePt∕Au multilayer structure

Growth of Mixed Phased Films of Γ-Fe2o3and Half Metallic Fe3O4using (100) MgO/Fe under Layer for Spin Electronic Devices

Structure and Properties of Fe 3 O 4 Films Grown on ZnO Template Via Metal Organic Chemical Vapor Deposition

Influence of oxygen flow rate and annealing temperature on composition, microstructure and mechanical properties of Fe–O films by reactive magnetron sputtering

Magnetic Anisotropy of Fe Films Deposited by Dc Magnetron Sputtering under an External Magnetic Field

Effect of (100) Oriented MgO/Fe Underlayer on Magnetic Properties of Fe3O4 Films

Modulation on the magnetic and electrical properties of Fe3O4 thin films through strain relaxation

Enhanced Structural And Magnetic Ordering Of Fept/Mn-Oxide Bilayers By Ion-Beam Bombardment And Annealing

Perpendicular magnetic anisotropy in the multilayer fabricated by alternate sputtering of Fe 3 O 4 /Cr and post-annealing

Enhancement of Magnetic Anisotropy for L10-(0 0 1) FePt Films Grown on SrTiO3 Substrate

The growth mode of α-Fe2O3 thin films by DC magnetron sputtering

Reactively Sputtered Fe3O4-based Films for Spintronics

The Success of Fabrication of Pure SmFe2 Phase Film with Outstanding Perpendicular Magnetic Anisotropy

Effect of the Sputtering Power on the Structure, Morphology and Magnetic Properties of Fe Films

Effect of Nano-Y2O3 Content on Microstructure and Mechanical Properties of Fe18Cr Films Fabricated by RF Magnetron Sputtering

Atomic Layer Deposition of Superparamagnetic and Ferrimagnetic Magnetite Thin Films

Magnetism of CoFe2O4 Thin Films Annealed under the Magnetic Field