Abstract:This study investigated the influences of plasma condition, concentration effect, ablation position and on-line addition of an aqueous Ni standard for non-matrix-matched Fe isotopic analysis by femtosecond laser ablation multi-collector inductively coupled plasma mass spectrometry (fs LA–MC–ICP–MS). Deviations up to ~0.7‰ in δ56Fe values caused by non-matrix-matched analyses were difficult to eliminate under dry plasma condition even with fs-LA. However, the nebulized water after the ablation cell efficiently reduces or eliminates the matrix-dependent fractionation of Fe isotopes without reducing signal intensity. Furthermore, concentration- and position-dependent fractionation of Fe isotopes was not observed under wet plasma condition. For instrumental mass bias correction, the standard–sample bracketing (SSB) method and SSB with Ni doping (SSB + Ni) were performed in the presence of nebulized water with fs LA–MC–ICP–MS. Results indicate that both the SSB and SSB + Ni methods are sufficient to correct for instrumental mass bias under wet plasma condition, with the SSB + Ni method being more effective in calibrating short-term fluctuations in mass bias with improved external reproducibility of ~0.15‰ (2SD) for δ56Fe values. Compared to SN–MC–ICP–MS, deteriorated precision offered by fs LA–MC–ICP–MS may represent a major limitation for some applications relying upon precise Fe isotope ratio measurements. This approach for non-matrix-matched analysis of Fe isotopes by fs LA–MC–ICP–MS under wet plasma condition combined with the SSB + Ni method allows for more flexibility in tracing detailed geological processes with large Fe isotope fractionation of a wide range of solids. Relatively precise and accurate Fe isotopic compositions of potential reference materials of Balmat pyrite (δ56Fe = −1.32 ± 0.12‰, δ57Fe = −1.91 ± 0.20‰; 2SD, n = 166) and PZH12–24 ilmenite (δ56Fe = −0.38 ± 0.15‰, δ57Fe = −0.57 ± 0.23‰; 2SD, n = 134) were obtained using this analytical protocol, consistent with reference values obtained by solution nebulization (SN)–MC–ICP–MS within analytical uncertainties (Balmat pyrite: δ56Fe = −1.30 ± 0.04‰, δ57Fe = −1.94 ± 0.07‰, 2SD, n = 3; PZH12–24 ilmenite: δ56Fe = −0.38 ± 0.06‰, δ57Fe = −0.55 ± 0.07‰, 2SD, n = 6).

Determination of the mass fraction of Ni in fluid cracking catalyst by X - ray fluorescence spectrometry

Application of X-ray fluorescence spectrometry in catalyst composition determination without standard

Quantitative determination of nickel speciation for the presence of free oxide in commercial fluid catalytic cracking catalysts

Determination of Ni,Al,P,Mg and Ca in Nickel Ores by Inductively Coupled Plasma-Atomic Emission Spectrometry

Determination of Trace Phosphorus in Cobalt-Niobium-zirconium Alloy by Inductively Coupled Plasma Atomic Emission Spectrometry

Determination of eight components in converter slag by X-ray fluorescence spectrometry

MCNP Calculation for Calibration Curve of X- Ray Fluorescence Analysis

Determination of Cr, Ni, Cu, Mn, P, Si, Mo and Ti in high chromium cast iron by inductively coupled plasma atomic emission spectrometry

Luminescence as a probe of metal poisoning effects on a high-activity fluid cracking catalyst (FCC)

Experimental Study on Ni Recycling from Fcc Dust by Induced Crystallization with Magnetic Nano Fe3o4@Sio2

Mesoscopic quantitative chemical analyses using STEM-EDX in current and next generation polycrystalline Ni-based superalloys

XPS fitting model proposed to the study of Ni and La in deactivated FCC catalysts

Use of a new magnetic ion–imprinted nanocomposite adsorbent for selective and rapid preconcentration and determination of trace nickel by flame atomic absorption spectrometry

Quantitative Deviation of Nanocrystals Using the RIR Method in X-ray Diffraction (XRD)

In-situ XAFS Study on the Crystallization Mechanism of NiB Nano-Amorphous Alloy

Evaluation of plasma condition, concentration effect, position effect, and nickel-doping method on non-matrix-matched Fe isotopic analysis by femtosecond laser ablation multi-collector inductively coupled plasma mass spectrometry

Simultaneous Determination of Ultra-trace Pt, Pd, Rh and Ir in Geochemical Samples by Inductively Coupled Plasma Mass Spectrometry Following Tin Fire Assay Preconcentration and Microwave Digestion

XRD measurement of stacking fault energy of Cr–Ni austenitic steels: influence of temperature and alloying elements

Determination of trace cobalt, nickel and cadmium by on-line flow injection analysis with coprecipitation preconcentration FAAS

Matrix effect correction method based on the main spectral parameters for rock samples in an in situ energy dispersive X-ray fluorescence analysis

Determination of manganese, nickel, copper, zinc, lead, rubidium and strontium in geogas samples by total reflection x -ray fluorescence spectrometry