Abstract:The high precision and low power consumption of the clock generator are critical in passive RFID transponders and passive IoT chips, but fluctuations in PVT can cause considerable degradation in the precision of the chip's internal clocks. This paper proposes a high-precision clock circuit with a single-shot calibration method to addresses this issue in a low-power clock solution. Based on the reference timespan in the preamble of the down-link RF envelope, a TDIF (Time-digital to current-frequency) calibration method was implemented with both a streamlined procedure and customized circuits. By computing the difference between the time counts and applying it to an ultra-low-power, current-starved oscillator, the current change ratio can be linearly controlled. Compared to the traditional integer frequency division scheme used by passive tags for a 160 k bits up-link data rate, the required frequency for the clock generator was reduced from 960 kHz to 320 kHz, the calibration error was reduced from ±10% to ±3% for ±25% frequency deviation, the calibration time was 133.3 μs for a single shot in this work, and the power consumption was 158 nW after the calibration was completed. This leads to an excellent power efficiency of 0.59 nW/kHz and meets the requirements of low power, low cost, and PVT robustness in the RF-powered passive IoT chips. By appropriately increasing the number of calibration digits and the duration, this calibration approach could also be used for other ultra-low-power passive IoT chips that require higher-precision clocking without the use of off-chip crystals.

Extremely Accurate Real-Time Clock Interface Design Based on DS3231

Design of All-digital Clock Recovery Unit Based on USB Device

The High-Precisiontime System Design of Pico-Satellite Based on GPS Receiver

High-Precision Timing System Based on Microcontroller

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

A High Accuracy Time Keeping Scheme Based on GPS

A Design of Real-Time Clock for Wireless Communication SoC in Smart Grid

Design of Multifunction Digital Clock Based on FPGA

Digital Perpetual Calendar Design Based on Single Chip Microcomputer

Design and implementation of Digital Electronic Clock System based on AT89S52

A Timing Scheme for Power System Based on Multi-Timing Source and Multi-Mode of Timing

Analysis and Design of 32.768khz Crystal Oscillator for RTC

System Design for High Precision RTD Temperature Detection

A design of digital electronic clock

Design of Digital Temperature Control System for Chip-scale Atomic Clock

A High Precision and Low Power Digital Synchronous Clock for Sensor Network

A 0.59 nW/kHz Clock Circuit with High-Precision Clock Calibration for Passive Internet of Things Chips

Intelligent electronic perpetual calendar

Design and Implementation of Precise Power Instrument Calibrator Based on DDS Technology

A 800nw High-Accuracy Rc Oscillator with Resistor Calibration for Rfid

Design and Analysis for High-Speed and High-Precision Clock Board