Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

Nanocrystalline ZnFe[sub 2]O[sub 4] and Ag-Doped ZnFe[sub 2]O[sub 4] Films Used as New Anode Materials for Li-Ion Batteries

Fe2O3–Ag Porous Film Anodes for Ultrahigh‐Rate Lithium‐Ion Batteries

Synthesis And Lithium Storage Performance Of Alpha-Fe2o3-Ag Hybrid Nanorod Anode For Lithium-Ion Batteries

Silver–nickel Oxide Core–shell Nanoflower Arrays As High-Performance Anode for Lithium-Ion Batteries

ZnFe2O4-nanocrystal-assembled Microcages As an Anode Material for High Performance Lithium-Ion Batteries

AlN-Fe Nanocomposite Thin Film: A New Anode Material for Lithium-lon Batteries

Single Iron Atom Anchored on ZIF‐8 Derived Carbon Framework to Directionally Regulate Lithium Deposition with Minimum Nucleation Overpotential

Cobalt Ferrite Thin Films As Anode Material for Lithium Ion Batteries

A Nanocrystalline Nio Thin-Film Electrode Prepared by Pulsed Laser Ablation for Li-Ion Batteries

Nickel Foam-Supported Porous NiO∕Ag Film Electrode for Lithium-Ion Batteries

AlN-Fe Nanocomposite Thin Film:A New Anode Material for Lithium-Ion Batteries

Al, B, and F doped LiNi1/3Co1/3Mn1/3O2 as cathode material of lithium-ion batteries

Nanocrystalline transition metal ferrite thin films prepared by an electrochemical route for Li-ion batteries

Li2ZnTi3O8@α-Fe2O3 Composite Anode Material for Li-ion Batteries

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Nanostructured NiSi thin films as a new anode material for lithium ion batteries

Atomic Layer Deposition of ZnO/TiO2 Nanolaminates As Ultra-Long Life Anode Material for Lithium-Ion Batteries

Synthesized Fe-doped Co3O4 nanoparticles-based anode for high-performance lithium-ion batteries application

Li2ZrO3-Coated Monocrystalline LiAl0.06Mn1.94O4 Particles as Cathode Materials for Lithium-Ion Batteries

A nanocrystalline Co3O4 thin film electrode for Li-ion batteries

Nanocrystalline NiO thin film anode with MgO coating for Li-ion batteries