Abstract:Schematic illustration of the experimental procedures followed for the hydrothermal growth of ZnO nanorods. In this study, ZnO seed layers with different cycles were formed on glass substrates by the sol–gel technique, and ZnO nanorods were grown on them by the hydrothermal method. Morphology and the structural characterization of the seed films and the ZnO nanorods are carried out by field emission scanning electron microscopy (FE‐SEM) and x‐ray diffraction techniques. In addition, to investigate the effect of seed layer deposition cycles on the optical properties of the ZnO nanorod arrays, UV/visible spectrophotometer and photoluminescence (PL) measurements were performed. The changes in structural and optical parameters such as dislocation density, strain, crystallite size, and optical band gap values on each seed layer deposition cycle were examined. The highest optical band gap and crystallite size were obtained for ZnO nanorods with 4 cycles seed layer as 3.22 eV and 63.6 nm, respectively. Also, in the PL spectrum, the largest ratio of UV‐emission region to weak‐visible emission region was obtained in ZnO nanorods having 4 cycles. In addition, the glucose detection properties of ZnO nanorods having 4 cycles were investigated using the PL measurements and it was found that UV‐emission peak intensity of ZnO nanorods decreased as the glucose concentration increased from 8 to 40 mM. The results show that the number of deposition cycles of the seed layer has a strong influence on the orientation, crystal quality, and optical band gap of the growing ZnO nanorods, as well as significantly affecting their morphological properties. Research Highlights High quality ZnO nanorods were grown on glass substrates by hydrothermal method. The effect of ZnO seed layer cycles on the structural, optical, and morphological characteristics of ZnO nanorods grown on were examined. It was found that the number of cycles of the seed layer is a critical parameter for growing quality and well‐aligned ZnO nanorods.

ZnO Nanorods on ZnO Seed Layer Derived by Sol–gel Process

Alignment-controlled Hydrothermal Growth of Well-Aligned ZnO Nanorod Arrays

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Effect of UV irradiation on the properties of ZnO nanorod arrays prepared by hydrothermal method

The effect of seed layer cycles on the structural, optical, and morphological properties of ZnO nanorods

Size-controllable Growth of ZnO Nanorods on Si Substrate

Hydrothermal Synthesis of Well-Aligned ZnO Nanorod Arrays on Silicon

Sequential Occurrence of ZnO Nanopaticles, Nanorods, and Nanotips During Hydrothermal Process in a Dilute Aqueous Solution

Influence of hydrothermal time on structural properties of ZnO nanorods grown on spin-coated ZnO seeding layer

Preparation of ZnO Nanorod Arrays by Seed-assisted Chemical Bath Deposition Method

The effect of pre-annealing of sputtered ZnO seed layers on growth of ZnO nanorods through a hydrothermal method

Optical Properties of ZnO Nanorod Array Grown on Li+-doped ZnO Nanoparticles As Seeds

Seed-Mediated Growth of ZnO Nanorods on Multiwalled Carbon Nanotubes

The Effect of the Texture and the Density of ZnO Seed Layer on the Orientation of ZnO Nanorod Arrays.

Growth of vertically aligned ZnO nanorods using textured ZnO films

Growth of flower-like ZnO on ZnO nanorod arrays created on zinc substrate through low-temperature hydrothermal synthesis

Aligned ZnO Nanorod Arrays Fabricated on Si Substrate by Solution Deposition

Controllable Growth of Highly Ordered ZnO Nanorod Arrays Via Inverted Self-Assembled Monolayer Template.

Nano/Micro-Structured ZnO Rods Synthesized by Thermal Chemical Vapor Deposition with Perpendicular Configuration

Effect of lattice strain on structural and optical properties of ZnO nanorods grown by hydrothermal method

Ordered Growth and Photoluminescence of ZnO Nano-Arrays on Silicon Substrates with Seed Film by Hydrothermal Method