Abstract:For single-core cables widely used in high or super-high power systems, induction voltage will cause circulating current flowing in the loop of the cable sheaths and the earth or the reflux wires. This current will produce additional losses, so as to reduce the current capacity of the cables, and the grounding wire will be burnt out when the heating effect is serious. Analyses on the circulating current in cable systems have been reported in some documents, but they are only for single circuit networks. In recent years however, two- and three-circuit cable networks are increasingly applied in cities, so accordingly the determination of the circulating current in these arrangements causes much attention. Thus the research work is focused on the calculation method for circulating current of a two-circuit cable network in linear arrangement. What presented first is the equivalent circuit for the circulating current calculation. Then the equations to calculate the circulating current in metal sheaths of two-circuit arranged cables are deduced and the basic principles of the solution program for this specific issue are provided. After parameter values are assigned according to the lay and operation condition of cables in two-circuit arrangement of a power designing institute, the circulating current in cross-bonded cable sheaths in linear arrangement are calculated. According to the calculation results, the analyses on influencing factors are carried out, and some possible ways to reduce the circulating currents are presented, such as to increase the earth resistance, to lay cables closely, and to make the cable length of every cross-interconnect segment equal. Besides, results from the single-circuit linear arrangement are also provided, for the comparison to be made with the two-circuit one. It is shown that two-circuit arrangement cannot be simplified as single-circuit when calculating circulating currents in cable sheaths. Although the calculation equations and the solution program in this paper are specially for the two-circuit linear-arranged cable networks, the technique for equation deduction and program design can be extended to cables in other lay conditions of two-circuit arrangement or even more circuit number.

Proximity effect and optimized arrangement of cable bundles

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Fast and Accurate Semi-Analytical Solution to Skin and Proximity Effects in Shielded Cable Systems

Efficient Modeling of Skin and Proximity Effects over Ultrawide Frequency Range, Part II: Multi-Conductor Arrays and Recursive Formulas

DC Electric Field Optimization of AC XLPE Cable Joint in DC Operation

Proximity-Aware Calculation of Cable Series Impedance for Systems of Solid and Hollow Conductors

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Calculation of Ampacity of Double-loop XLPE Cables in Trenches Based on Multiphysics Simulation

Optimization and improvement of ac resistance calculation method for multi-phase parallel-wiring cables

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Electric field calculation and optimization for stress cone of DC cable joint based on the coaxial double-layer insulation model

Simulation and Calculation of Proximity Effect of Coils under Fast Transients

Calculation of Eddy Current Losses in XLPE Cables by FEM

An Efficient Method of Calculating Inductance Using Near-Field Data

Study on Current Distribution in Same Phase of Two Parallel Large Section Cables Based on FEM

Accurate Formulation of the Skin and Proximity Effects in High-Speed Cable System

Calculation of Circulating Current in Sheaths of Two-circuit Arranged Cables and Analyses of Influencing Factors

Simulation and Analysis of Polypropylene Cable Based on Electro-Thermal Multi-physics Coupling

Calculation of distribution cable steady and transient temperature field in ducts

Comparison of Different Methods for Calculating Electrical Parameters of Power Cables

Optimization of ampacity for the unequally loaded power cables in duct banks