Abstract:For single-core cables widely used in high or super-high power systems, induction voltage will cause circulating current flowing in the loop of the cable sheaths and the earth or the reflux wires. This current will produce additional losses, so as to reduce the current capacity of the cables, and the grounding wire will be burnt out when the heating effect is serious. Analyses on the circulating current in cable systems have been reported in some documents, but they are only for single circuit networks. In recent years however, two- and three-circuit cable networks are increasingly applied in cities, so accordingly the determination of the circulating current in these arrangements causes much attention. Thus the research work is focused on the calculation method for circulating current of a two-circuit cable network in linear arrangement. What presented first is the equivalent circuit for the circulating current calculation. Then the equations to calculate the circulating current in metal sheaths of two-circuit arranged cables are deduced and the basic principles of the solution program for this specific issue are provided. After parameter values are assigned according to the lay and operation condition of cables in two-circuit arrangement of a power designing institute, the circulating current in cross-bonded cable sheaths in linear arrangement are calculated. According to the calculation results, the analyses on influencing factors are carried out, and some possible ways to reduce the circulating currents are presented, such as to increase the earth resistance, to lay cables closely, and to make the cable length of every cross-interconnect segment equal. Besides, results from the single-circuit linear arrangement are also provided, for the comparison to be made with the two-circuit one. It is shown that two-circuit arrangement cannot be simplified as single-circuit when calculating circulating currents in cable sheaths. Although the calculation equations and the solution program in this paper are specially for the two-circuit linear-arranged cable networks, the technique for equation deduction and program design can be extended to cables in other lay conditions of two-circuit arrangement or even more circuit number.

Optimization and improvement of ac resistance calculation method for multi-phase parallel-wiring cables

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Investigation on Loss Reduction Strategies of Single-Core HVAC Submarine Cables

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Study on Current Distribution in Same Phase of Two Parallel Large Section Cables Based on FEM

Calculation of Ampacity of Double-loop XLPE Cables in Trenches Based on Multiphysics Simulation

Efficient DC and AC Impedance Calculation for Arbitrary-Shape and Multilayer PDN Using Boundary Integration

Proximity effect and optimized arrangement of cable bundles

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Research on the Optimization of Grounding Methods and Power Loss Reduction Based on AC 500kv XLPE Submarine Cable Project

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Electric field calculation and optimization for stress cone of DC cable joint based on the coaxial double-layer insulation model

A Power Flow Calculation Approach for Distribution Network of Pure Power Cables

Estimation of Overhead Transmission Lines ACSR Combined Elastic Coefficient

Calculation of Circulating Current in Sheaths of Two-circuit Arranged Cables and Analyses of Influencing Factors

An AC resistance optimization method applicable for inductor and transformer windings with full layers and partial layers

Improved thermal analysis for three-core cable under unbalanced three-phase loads

Algorithm for Fast Calculating the Energization Overvoltages along a Power Cable Based on Modal Theory and Numerical Inverse Laplace Transform

Calculation and Analysis of 220kV Cross-River Cable Carrying Capacity Considering Complex Environments, Part I — Analysis of Thermal Problems for the Entry Section of Overhead Transmission Line to Underground Cable