Abstract:Silicon Photomultiplier (SiPM) has been demonstrated to be a high performance PET sensor as alternative to conventional photomutiplier tubes. The aim of this work is to develop a PET detector module with compact SiPM device which consists of 3x3 SiPM arrays (4x4 pixels each array, 3.17x3.17 mm(2) each pixel). A compact design of readout electronics is proposed based on discretized position-sensitive readout circuits (DPC) and time based readout ASIC. The function of the ASIC is to convert all signals' energy and timing information into digital timing pulses which can be processed by back-end simple Time-Digital-Convertor (TDC). So we get highly integrated electronics because the traditional Analog-Digital-Convertor (ADC) and Constant-Fraction-Discriminator (CFD) are replaced. A temperature-dependent gain control module including a microcontroller, a DAC and a DC-DC converter is designed to stabilize the gain of SiPM arrays against the variance of ambient temperature, which is based on the temperature sensor and serial identification chip intergrated in the SiPM array package. An preliminary experimental study was conducted, in which one SiPM array was coupled to a 6x6 LYSO crystal block. With a resistor charge-division chain readout circuit, a flood histogram map was acquired in which the crystals were clearly identifiable. With the correction of the gain control module, the maximum gain drift of SiPM decreases from 79.67% to 11.03% as the temperature varies from 27 degrees C to 50 degrees C. The result indicates that the developed gain control module can contribute to improving the stability of SiPM based PET detector. Through some basic tests, the ASIC has demonstrated good performances of linearity and uniformity. We conclude that the proposed design is feasible for developing a compact SiPM PET detector module.

Development and Application of a Multi-Anode Microchannel Array Detector Testing Platform

Design of a Multi-Anode Microchannel Array Detector System

Novel Mlaps Using the Multilight and Digital Compensation Technique

Studies of A Solid Detector Array for High Energy X-Ray Imaging System Based on Ma-Pmt

Development of a multi-channel readout electronics verification system for MWDC detectors

Segmented Anodes with Sub-millimeter Spatial Resolution for MCP-Based Photodetectors

Setup of a photomultiplier tube test bench for use at LHAASO-KM2A

Development of MEA-based Olfactory Neural Chip and Its Testing System

Performance testing of a novel short axis photomultiplier tube for the HUNT project

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

Application of CMOS Charge-Sensitive Preamplifier in Triple-Gem Detector

Studies of Pad Matrix Readout Concept for Multi-anode Photomultiplier Tube

A Compact Readout Electronics Based on Current Amplifier for Micromegas Detector in Muon Imaging

Simulation of DAMPE silicon microstrip detectors in the $\rm Allpix^{2}$ framework

Fabrication and Characterization of a High-Performance Multi-Annular Backscattered Electron Detector for Desktop SEM

A multi-channel readout electronics system for GEM and MICROMEGAS

A Compact Readout Electronics Based on Current Amplifier for Micromegas Detector in Muon Image

Study of Detector Unit of Micro-PET

A Testing Approach for MOS Circuit Using Single-Photon Detectors under High Magnetic Fields