Abstract:Crystallographic textures and their effect on the mechanical anisotropy of a hot-rolled biomedical Co-Cr-Mo alloy were investigated. The hot-rolled Co-28Cr-6Mo-0.13N (mass%) alloy examined here exhibited a monotonic strength increment following hot-rolling reduction, eventually reaching a 0.2% proof stress of 1400 MPa while maintaining acceptable ductility (>10%). The dominant hot-rolling texture was a brass-type component, which is characterized by the alloy's peculiarly low stacking fault energy (SFE) even at hot rolling temperatures, although the minor peaks of the near copper component were also identified. However, because of the onset of dynamic recrystallization (DRX) during the hot rolling process, the texture intensity was relatively weak even after 90% hot rolling, although the grain refinement originating from the DRX was not significant (the "less active DRX" condition increased the strain accumulation during the process, resulting in high-strength samples). The weakened texture development resulted in negligible in-plane anisotropy for the hot-rolled specimen strength, when the specimens were tensile strained in the rolling direction (RD) and transverse direction (TD). The elongation-to-failure, however, exhibited a difference with respect to the tensile loading axis. It is suggested that the ductility anisotropy is closely related to a strain-induced γ (fcc) → ε (hcp) martensitic transformation during tensile loading, resulting in a difference in the proportion of quasi-cleavage fracture surfaces. The obtained results will be helpful in the development of high-strength Co-Cr-Mo alloy plates and sheets, and have implications regarding plastic deformation and texture evolution during the hot rolling of non-conventional metallic materials with low SFE at elevated temperatures, where planar dislocation slips of Shockley partial dislocations and thermally activated process interplay.

Evolution of texture during hot rolling of aluminum borate whisker-reinforced 6061 aluminum alloy composite

Fiber texture evolution of hot-rolled aluminum matrix composite reinforced by aluminum borate whisker

Texture gradient in rough-rolled plate of aluminum alloy 3104 and its effect on annealing textures evolution after hot compression

Effects of Rolling Temperature on Hot Rolling Behaviors and Mechanical Properties of ABOw/6061Al Composites

Deformation and Recrystallization Textures in Straight-Rolled and Pseudo Cross-Rolled AA 3105 Aluminum Alloy

A Study of Hot Rolling of 6061 Aluminum Alloy Matrix Composite Reinforced with SnO2-coated Al18B4O33 Whisker

Hot rolling behaviors of whisker reinforced aluminum composites

Texture Evolution of Hot-Rolled, Near- α -Based Titanium Matrix Composites

Texture and mechanical properties of warm rolled Fe3Al alloy

Rolling and annealing textures of a SiCw/Al composite

Texture, Microstructure and Mechanical Properties of 6111 Aluminum Alloy Subject to Rolling Deformation

Improved Mechanical Anisotropy and Texture Optimization of a 3xx Aluminum Alloy by Differential Temperature Rolling

Effects of Different Modes of Hot Cross-Rolling in 7010 Aluminum Alloy: Part I. Evolution of Microstructure and Texture

Texture Evolution of AZ31 Magnesium Alloy Sheets During Warm Rolling

Effect of Al addition and rolling reduction on microstructure and texture evolution of Mg–3Sn alloy during high-speed rolling

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Texture evolution and mechanical anisotropy of biomedical hot-rolled Co-Cr-Mo alloy

TEXTURE EVOLUTION OF POLYCRYSTALLINE ALUMINUM DURING ROLLING DEFORMATION I.Experimental Study

Microstructure study of hot rolling nanosized in-situ Al2O3 particle reinforced A356 matrix composites

Abnormal texture evolution of accumulative roll bonded Al-Cu by adding alumina particles

Mechanical properties and texture evolution during hot rolling of AZ31 magnesium alloy