Abstract:To investigate the bearing capacity and force mechanism of a steel and concrete joint section in a hybrid tower and on the basis of analyzing the stress of the front bearing plate, rear bearing plate, and plug-in joint section, finite-element models concerning the back bearing plate based on a specified pylon joint section of Yuejiang Bridge in Zhaoqing City were conducted to study the mechanical behaviors of the joint section. According to the calculation results of the model, the shear force of the shear studs in the back bearing plate joint section increases gradually from top to bottom. The farther away from the bearing plate, the greater the shear force borne by the shear studs, and the peak value was reached at the bottom of the joint section. The axial force transmitted by the bearing plate accounts for 68% of the total axial force, and the other axial forces are transmitted through shear nails, which has a good force-transmission effect. An experimental specimen with back bearing plate and with a reduced scale at 1:4 of the single limb of a tower was conducted, and structural deformation and stress distribution were measured. The results show that the existence of a bearing plate and its position in the connection will lead to a different shear force distribution of the shear connectors. The joint section with back bearing plate has an excellent bearing capacity and can transfer force fluently from the steel tower to the concrete tower. The tested specimen basically kept a linear behavior in the whole loading process. The steel plates in the connection hold a gradually decreasing stress distribution downward, while the distribution of concrete is opposite. The maximum relative deformation between steel and concrete was about 0.1 mm in this test. The hybrid connection with a back bearing plate has a good application in engineering. In view of the test results that the stress level of the concrete under the bearing plate was slightly higher, the C60 concrete with steel fiber in the steel–concrete joint section was used to improve the compressive capacity of the structure. At the same time, to improve the stress-concentration phenomenon of concrete at the corner of bearing plate and wall plate in steel–concrete joint section, the trial mixing test and grouting were used to ensure the compactness between steel and concrete, and good use effect was achieved.

Experimental research on enhanced hemisphere node in mege-frame steel structure

Experimental study on reinforcing moment connections for square steel tubes in National Swimming Center

PERFORMANCE RESEARCH ON LARGE CAST-STEEL NODE UNDER COMPLEX STRESS STATE

Experimental study on seismic behavior of assembled steel beam-PC column composite frames

Experimental Research on a Composite Structure Combined of Cable Dome and Single-Layer Lattice Shell

Experimental Study on Self-Centering Link Beams Using Post-Tensioned Steel-Sma Composite Tendons

Experimental research and finite element analysis on tubular joints of Hangzhou East Railway Station

Seismic Behavior of Pc Column and Steel Beam Composite Moment Frame with Posttensioned Connection

Research on Key Joints Design of Mega Frame of the Shanghai Tower

Experiment of welding reinforcement of end-plate connection nodes in steel-structure under loads

Experimental research on especial shaped steel reinforced concrete column with large quantity of steel in Qsingdao Wanbang Center

Loading System for Full-Scale Heavy-Duty Support Node Test with Multi-Directional Loading Requirements

Experimental Research and Finite Element Analysis on Joints of Sun Valley Steel Structure for the Expo Axis Project

Experimental study on the seismic performance of beam-to-column composite connections in medium-high strength steel frame structures

Experimental studies of full-scale self-centering beam-to-column exterior connection

Experimental Research on the Bearing Capacity of a Steel and Concrete Joint Section in a Hybrid Tower

Research on the Compression-Bending Behavior of Concrete-Filled Double-Steel-plate Composite Bridge Towers

Experimental study on seismic performance of frame with steel-hollow core partially encased composite spliced beam

Experimental Study and FE Analysis on New Frame Joints of Concrete-Filled Steel Tube Structure

Research on Complex Steel Components and Node Forming Technology in Guangdong Science Center

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams